Finally got around to doing installing the shadow 2 mag release pad on my TSO and blending the magwell after procrastinating for a long time. I cut off about 3mm from stock TSO mag release, drilled and tapped for an M3 x .5mm screw.
I installed a 2mm roll pin so I can change the position of the pad just like the shadow 2. I also crimped the mag release release spring a little bit so the pad is softer to press in ejecting a mag. Works just like my shadow 2 now.
my cat checking it out too. Also installed a Trijicon dual illuminated RMR and removed the slide ride to trim some weight.
Blended the magwell using a tungsten carbide cutter on my dremel followed by 180, 240, 320 and 600 grit sanding drum. Then polished it with mother’s mag polish.