AHI

what is the load for the standard pistol and do you use the same reloading press?

Just like on the 550 remove the priming system and pour them out. or cycle the handle 100 times.

sand paper IE more scratches

normal with all presses dies etc.

The 1500 takes up 3 stations the one before and after the one its in. is smaller than the router that mark 7 currently uses. I would recommend the 1500 if you plan on converting 223 to 300 Black out over the Giruad. Your fingers will cramp up very quickly. trying to do this.

they could but probably not depends on what powder you use etc.

yes they will work. you may wont to drop your powder charge and work back up .

I am having issues with a43X same ammo in 3 gen3s and 1 gen4 does not. anyone else ?

there are two https://reloadinginnovations.com/collections/led-reloading-press-lights/products/dillon-1050-press-lighting-kit https://inlinefabrication.com/collections/lighting/products/skylight-for-the-dillon-1050 both work

mister bullet feeder led light system

I remember 15ish years ago Castrol and Moble packing there engine oil in little bottles /cans and promoting them as gun oil.

this is the most likely cause . if the round had been fired the bullet would no longer be in the case. Bullet setback IS mostly a joke. Does it happen? Yes. Can it affect function? Yes. Will it cause a "kaboom"? Not likely.

powder was discontinued several years ago many people liked it .but most have moved on to better and available powders.

#1 the length listed is the length they tested #2 the length listed should fit in all guns chambered in that caliber. Notice I said SHOULD did not say would. #3 provides optimize bullet pull retention. Thar fore optimizes pressure for a "clean" complete burn or the propellant (powder) #1 and#2 are the main reasons

2 toolheads for 223/5.56 first one has dillon trimmer etc and do a light swedge. second tool head loads and finishes the swedge. easiest way and less stress on press and you.

yes 550 for work up and odd calibers and a 1050 for production. also will add 80% of the brass I get has crimped primer pockets.

The lens coating on the rmr causes issues with some peoples vision. IE it a blurry mess or they can not find it at all. But they can see the FF3 with no issues.

The 750 is not a upgrade from a 650. And that is from someone who does not like the 650.

YES

DELITE

Did you read thread from the beginning ? NO YOU DID NOT. Loads were fired in a 2011 style gun. NOT A GLOCK. Brass was a mixture or head stamps. NOT STARLINE.

no but this is old news very old news in fact

no psi problems . I use regular small pistol primers' nave miked the cases for expansion at the base. actually have went higher 7.8 before any psi issues started . length is 1.65 -1.70 . power factor is 168-172

like I said after 15 loadings most sane people would have stopped

two Procedurals all targets were engaged all targets were hit