zombywoof

Stock 2

This is what I do. The start of every session. Maybe take an average of three cases

https://www.gunsprings.com/EAA/cID1/mID19/dID100#853

I grind a small dimple into the slide stop where the plunger contacts it.

The height of the optic really makes no difference to me. You will get used to it in no time.

I also had a frame replaced, they added an "A" at the end of my original serial number. I'm only going by this note they sent me.

NO

Started in 2015. Damn

I ordered mine recently from their website

Headstamp?

Thanks!!!

I use one of these Excelta pen brushes with a little Hoppes. They work great. They come in brass and stainless steel. It gets down in the port and scrapes off the carbon very easily.

Where do I find one of these tools? Estonia? any vendors in the states?

Sport Pistol, WST or N320

Our local Sportsmans Warehouse got in batch of primers, 200 per person limit. Made a few trips over a couple days. Hit it once and 9mm was on a rack behind the counter, 100 round limit $18.99 per box of 50. Picked up a couple boxes for a fellow shooter with low supplies.

Is your ammo in a major power factor? Not sure the S2 in it's stock configuration is meant to take major ammo. A barrel switch should be easy. I can tell you I ran 9mm in my S2 with 38 super mags with no problem.

Guys I worked with, one drag raced a twin turbo mustang, another was a tournament bass fisherman. The money they threw at their hobby was amazing. I always point that out to the wife.

Get a 10 pack direct from Wolff, lots cheaper.

replace extractor spring with Xpower

Get a 22 rifle bore brush. It fits in the extractor channel nicely and cleans easier and faster.

I bought this one pound bag of pine resin to try for about $15. It's little crystals. It works great in the cold but does get a little sticky when it's hot out. https://www.amazon.com/Essential-Living-1LB-Powdered-Beeswax/dp/B0747TRC9L/ref=sr_1_9?dchild=1&keywords=pine+resin&qid=1615551886&s=sporting-goods&sr=1-9

Springs and ammo

Depends on the ammo. I've had to put the original hammer spring in for Aquilla.

They'll drive you nuts after a while, only in the way.

you could always pop the primers out, clean the brass and reuse them if you must clean the brass. I would just resize without the decap pin and reload.