Jump to content
Brian Enos's Forums... Maku mozo!

zombywoof

Classifieds
  • Posts

    852
  • Joined

  • Last visited

Everything posted by zombywoof

  1. Lyman trigger pull gauge, cleaning rod with handle, screw and a couple washers. Slip spring onto rod with a washer on each end 8/32 screw in the end of cleaning rod. Pull rod between the jaws of my vise (using the trigger pull gauge) with the one washer on the end of the vise.
  2. This I've done it and it works if you're careful. Just for practice though.
  3. I guess you could put a small ball bearing in there and stake it in.
  4. I ran it for a while in minor. I seem to remember velocity swings. It worked but that's about it.
  5. are there differences in bullet diameter?
  6. I've been using the LEE 356-125 RN with great success
  7. In four open guns the Hi-Tek coated bullets leave lead accumulation in the comp and smoke. The Blue bullets smoke less and leave the comp much cleaner.
  8. That hammer pin must have been fun to install
  9. They are much harder than Federal
  10. Quick google search shows single action and magwell. So, no, limited minor.
  11. Try them first, if they don't work you'll have to make them.
  12. install spacer if they don't work, my 38's worked in my S2
  13. I practice my DA a bit. Then I tape the hammer back with a piece of tape wrapped around the beaver tail for SA.
  14. This is what I do. The start of every session. Maybe take an average of three cases
×
×
  • Create New...