vernbo

find a smith that can do this

I fixed a friends canik stovepipes with a kingglock 13 # guiderod with adapter cup , then the fireing pin spring was strong enough to sometimes hold out of battery causing light strikes , which i fixed with a glock fireing pin spring now he reports all good .

have you tried shooters connection?

yes, I use Wilson 45 mags in my 40 s&w & my 10 mm single stack guns . I don't even have any 40 mags.

checkout this thread http://www.brianenos.com/forums/index.php?showtopic=46977#entry537645 my post number 10

I think they are chambered longer because , when loading to the high power factors in uspsa the long freebore lessens high pressure spikes .

bolt is 10-32 x 1 1/4 there is also bushing , bowed washer , nut , are they still there?

if you read this thread http://www.brianenos.com/forums/index.php?showtopic=46977#entry537645 post-- number 10-- that is how i stopped the rounds from getting bellow the follower with sti mags .

check daa , kit for fitting grip to your hands. Grip Customization Kit Overview and Instructions

fastshooter 03 i have one of your toolheads that i use for supercomp ,it has been a very good fix for the mis alinement on the resizing station.

this

should be an e-mail from practiscore with link to go back to squad list.

check list before leaving for matches. bullets go in ,mags mags go in , gun gun goes in , holster take all of those things with you.

did it get colder those last matches ? lube to thick !

rcbs trim pro with three way cutter. powered with cordless drill. not my video .but just like my setup.

how about one nut off of each link top or bottom ,left or right?

http://moaprecision.com/cgi-bin/imcart/display.cgi?item_id=m3k-cp-parts&cat=3&page=1&search=&since=&status=&title= try here.

COM holsters , will make what you need.

don't remember all details ,but have read before about putting barrel in freezer ,brass shrinks faster than steel ,than find a tight bore brush that will grab the piece.

did you check if Jerry pawned the Steyr

`another trick for flathead screws . after you have melted loctite. use a very sharp pointed center punch and hammer on almost outside edge , leaning on a reverse direction and tap the screw out.

I load 40,s out to 1.200 and use wilson 45 mags. works fine.

if the top round is moving forward a fix , polishing the disconnector rail might stop round from moving ,it has worked for me.

you can also place gun in one or more heavy zip lock bags, heat holster then force into holster.

are these american made?