chevrofreak

For progressive loading I much prefer the Hornady custom grade seating dies for both rifle and pistol. For single stage, I love the RCBS Gold Medal seating die. That bullet window is genius.

I load them with 3.8gr of Titegroup for minor use, and I recently ran them through my G17 with Strike Industries Mass Driver Compensator and there was very minimal lead residue left behind. I think a slower, cooler burning powder would prevent nearly all leading.

Seems to be the new thing. The Blue Bullets does this now as well.

I run my M die on my loading toolhead. I wet tumble again after sizing and trimming to get the lube off and to knock more shavings off.

It seems to tilt the .223 cases a bit too much.

I've read that it requires you to buy parts to do it. I do like the idea of being able to run the probe and also swage on the same processing pass.

I hope I get mine soon; I am at almost 7 months since I ordered.

Has to be quarantine or stock based.

Kind of makes it pointless to use an SRP then. I've had a lot of failures with S&B SRP in my Glocks so I won't load any pistol ammo with SRP anymore because of it.

Many striker fired guns won't reliably fire an SRP

Same here; it was a bad time to get into reloading. Now, I have enough supplies to last a couple of years, but I am always replacing what I use when I can.

Go for a round nose bullet like the Everglades V2 JHP to allow you to load a bit longer. Glock mags don't work with OAL above 1.169", and need even shorter if you use a conical JHP. I would recommend a load of 7.7gr of Silhouette under a 124gr bullet, or 8.3gr under a 115 Everglades V2 loaded to about 1.16" with a small pistol primer (not Federal) for reliable ignition.

I bought 3k of the Federal AR Match for 39.99/k. I think they seat just fine in my new Nammo Tactical brass.

Does it roll like the JP?

I dont load that powder for PCC anymore. I run a hotter charge of Power Pistol or BE-86. People say a brake won't work on a 16" 9mm because there isnt enough gas, but the visible flames in each port when running Power Pistol say otherwise.

The strange thing is that I have only ever had pierced primers with N350. I can't explain it.

I need to get my hands on some. Wolf Gold 55gr is quite accurate, and the brass is super consistent.

Makes me wonder if some SPP found their way into a batch of rifle ammo

Higher amp output helps, because there is a surge of current when the radar is triggered. I have used a 10k mAh pack multiple sessions with plenty of reserve left. AA NiMH also works well, but is not as convenient.

I used to load something like 4.4gr of N350 under a 115 plated bullet. I could stack shots on 25 yard targets as quick as I could pull the trigger. It also had a ton of pierced primers, which caused me to switch to rifle primers.

It is apparently the old Accurate #5.

This, or a HS502C

Blown out of the case, with the pocket and case head so expanded that the brass cannot be reused.

I've had Blue Bullets scrub my barrel very clean after I got leading with SNS bullets, but I haven't tried them to clean up heavy lead.

That load blows 100% of the primers in both my CK and Glock open pistols.