Jump to content
Brian Enos's Forums... Maku mozo!

chevrofreak

Classifieds
  • Posts

    770
  • Joined

  • Last visited

Everything posted by chevrofreak

  1. Tiger is awesome. He took better care of me than ever necessary.
  2. I've made 200PF+ in 9mm without fragging a gun. There were no primers left, and the case heads were oval, but the gun was fine.
  3. The first rule about Fight Club, is that you do not talk about Fight Club.
  4. I dont think I can order any more without getting a knock on my door.
  5. Funnel, plate and "kisser". It should take minutes.
  6. Ditch the oil and get yourself some Lubriplate SFL-0 or SFL-00. These greases are non-polar, so thwy wont attract the gunk. They are also very thin and perform like oil.
  7. That natoreloading site says it is one of the cleaner powders they have tried.
  8. You can probably pull it off, but you may have to sort by headstamp. FC seems to be the easiest to seat deeply in.
  9. Not yet. I likely will soon. Once my RL1100 shows up I will probably leave my 650 set up in .223. My Autotrickler V3 showed up this week, so I am stepping up my rifle reloading, but all of my .223 brass is either new or already processed and primed. I would rather not Rollsize primed brass, but we will see.
  10. The Feedinator is fast. Very fast. It needs some break in of the 3D printed parts, and the collator plate should be removed and everything cleaned from time to time. I am also running this thing wide open at 6100 rounds per hour on a Rollsizer. No press can run that quickly. The jamming issues I have experienced are dramatically reduced at lower speeds, as the Feedinator uses an adaptive drive that doesn't spin the collator faster than necessary. So far I have Rollsized over 25,000 pieces of 9mm brass, and if I had to do everything over again I would still buy the Feedinator.
  11. I would like to see that option as well. Perhaps even a 16moa ring option.
  12. My CK will throw them into a 1" group at 25 yards when loaded to 1.145" and flying at 1500fps.
  13. Just the 5.1gr N350 load, which did 1046fps from my CZ P10C. The load is an 147gr HST at 1.125" over 5.1gr of N350 in a nickel FC case with a CCI SPM.
  14. They shoot great out of my guns loaded over 3.8gr of Titegroup and an OAL of 1.085"
  15. BE-86 and N350 are my favorite SD powders, but I lean toward N350. A 5.1gr charge will get you where you want to be.
  16. My precision AR that I shoot suppressed did this last time I shot it. I just opened it up and oiled the spring struts and it ran the rest of the shooting session.
  17. I don't think anything runs cleaner than 3n38.
  18. This. I had leading with every other coated bullet I tried.
  19. 8.6gr of HS-6 is a good load behind a 115.
  20. The solar panel also charges an internal supercapacitor. The 510C will work with no battery, in the pitch dark, if it has a charged capacitor.
  21. If it is an exposed lead base it isn't ideal for compensated pistols. If you want to go down this road anyway, flat point bullets load nearly identically to many common JHP bullets, like Precison Delta and Hornady HAP.
  22. Removing the slide may give enough clearance.
×
×
  • Create New...