mwx40x40

Marley coffee One Love.

^^^^^^THIS is good advice

It may have been a break in issue, but all I have done is leave my mags fully loaded for a few weeks and have no longer had any issues. I know this does not make sense, but my nosedive issue has disappeared.

Are you by chance using Titegroup powder?

Still be interesting to see what Olhasso can do with one

Best news I have heard in a long time

The little Seafood restaurant right at Hwy 56 & I26 is not bad. Not sure . But think it is called Blue Marlin

Can also go to Lowe’s/Homedepot and get a draw pull. They are typically threaded 8/32

Thanks,just checked out the PMACA items. Looks like good stuff for ultimate steel challenge build.

What tube and stock?

+1

For years as a one day match it was always a sellout. So, it’s a two match now to better accommodate everyone. Very much look forward to this match every year.

With the current weather we are getting, AC most likely will not be needed.

^^^^^^another vote for Clays/claydot

Thanks guys

There is a difference, but only a few thousandths. So it depends on holster. Custom molded kydex for 1.0 probably going to be tight on 2:0.

Also just depends on where you are at and number of classic enthusiast in the area.at my home range the only ICORE match we shoot is the annual postal match. Out of the 6 shooters that showed up, four were Ltd, two classic. However, 2 1/2 hours away another club host monthly ICORE matches and 80% or more of these guys shoot Classic.

Powder Valley

Assuming you might be shooting that match at PGC. They’ll take good care of you.

Have not run it much sinceinstallled , but have not noticed any wear. Long term use I cannot vouch for yet.

Hyve makes a nice one. Not overly extended like some

What mount is used with reddot and did you remove front sight or cut barrel back?

Wished they would have included revolver in this

Let us know how this goes with A400 barrel

3.3 gr CLAYS under 160 Bayou. Soft, clean and accurate. Clay dot will also work.