AHI

Good plain. HS 6 will be dirty at true 125-135 minor loads. If you go to 140-150 Power Factor.( factory Self Defence PF) It cleans up quite well. and You may get a little use of your comp.

Any body else notice all(mose) the problems. With aftermarket enhancements. Magazines, Triggers and guide rods for example. Primarily involve the gin 5.???

20 ish fps

Everglades ammo / bullets. In Florida does or at least did offer. 9 major ammo.

I would check that ammos OAL before buying a bunch.

Agreed also . Having "worked" with two CZ open guns with unthroughted chambers. He is Two plus grains over what is needed to make 170 power factor. And well into primer popping territory. Which is just under parts flying territory.

hear is one under a different brand https://www.jdindustrialsupply.com/topcote.html?utm_source=bingshopping&utm_medium=cpc&utm_term=topcote&utm_campaign=cse&msclkid=0efa9372620a1181a355f29c88bf846b

I can feel it .If I have the swage set. yes it is a spongy feeling.

just asking because clays is the only powder . That I know of that reacts with Hornady one shot. Had the same issues. Plus a lot of failures of the powder to fully burn. never had the gummy residue. My procedure at that time was to load as much ammo as I could in the cold months. Went back to Bullseye powder and some N310. All the issues went away. This was when I only shot Bullseye competition and skeet.

clays powder?

start hear then proceed. This should help you identify the product. This is only one of a few. At one time you cold get just the lube. https://multimarketingco.com/tool-surface-lubricant/

When you push on the firing pin. Will the tip come through the firing pin hole?

Only time I have had a primer detonation. Was a rung primer. Wasn't using the swage at the time. After that always used the swage. Now all brass is "processed". Puts an end to all kinds of problems.

Hornady one shot. Is actually a saw blade lubricant. That's rebranded. Do a little research. The info is out there. When I did. Found that the Hornady was/ is. Less expensive for me to get. Others may find the wood working Version. To be less expensive.

The 115s will still have a"crack" when fired. A 147 or 160 at 900 fps. Will not. The altitude, temperature and humidity . Have less true effect. Than what the Charts imply. If you want subsonic it has to always be low enough . No matter what the Temp, humidity, altitude is.

the link provided above works fine.

The after market part . Was junk. That's why a lot of people say not to change parts. I don't fully agree with that. Buy have seen that all parts are not created equal. Some are down right trash.

Nitro 100 was one of the worst powders I have tried in pistol. Very inconsistent. Dirty just would not burn. Velocity swings. Shall I continue? RS Competition is a powder I've never tried. If you like it . Can get it. That would be the one to use.

nitro 100 says this For centerfire metallic cartridges please use load guide version 3.5 or later.

is this what you are after it list one pistol loading in 9mm. https://shop.hodgdon.com/ramshot/ramshot-competition

Coffee should be Hot, Black and Bitter. So yes that is a cup of milk.

this statement. implies the product is ready . no boxes to put them in would be a reason for example.

After reading this. One gets the impression that there are guns ready to ship. So why not ship them?

A lot of pull weight . Is in the striker spring. 4.5 pound gives me the best. Ballance of pull weight and reliability.