eerw

balance of weight and springs. need lighter comp, light springs to get the gun to cycle correctly and effectively. mine I use a little hotter factory ammo to get the slide speed up and the comp to work a little bit.

Firing pin should be OK, would be surprised if the shoulder is out of spec. Would look at FP spring if applying enough pressure on the FP. biggest firing is that pin is not back firm enough to make sure FP plate is retained. Could always go to CZC parts

Which FP spring are you using? just so I understand. the firing pin spring is not pushing the FP back far enough agains the plate? did you try the factory FP spring? or the 2075 FP which is the lightened one we use.

the sear should move freely up and down. so check your spacer for burr or similar.

This

while I love CZs, uh...no. You should be able to move your glock for a fair price and come up with a decent Pre B and enough for parts to upgrade.

would work. the P09 mag and pad is 140mm would just take the chance of over-insertion at slide lock , but shouldnt be an issue as you should be at slide lock in CO anyway.

Our latest batch of P09 mags are P10 compatible

we have some parrots in stock too. czcustom. call/email

What magazine tube are you using?

Best would be a 9mm upper with firing pin block. your only other option is try SP01 barrel and 9mm extractor. If your SP01 40 came with the mecgar 40sw12 rnd mags, they will fit 9mm

We have a few left at CZC

Oh break my heart.

We talked with Troy. Rear sight plate is good to go back to production.

Yes . Talked with Troy, he said my matched the profile and no change of weight he was good with it. also it is milling for a rear sight which is alllowed.

We have a plate for the DP Pro. we can work with just the slide. Thank you

we are running about 8-9 weeks on machine work.

Challenge has been to 1. how to fit RMR on the narrow 75 slide. 2. offer back up sights. Here is an option we came up with at CZC. Using the Trijicon RMR sight plate. You can mount the RMR dot and offer tritium night sights as a back up. Looks pretty good too.

Here is the RDS plate system for the SP01 Shadow / 75 Shadow. able to mill the slide for interchangeable plates. For the SP01 Shadow / 75 Shadow we also have a rear sight plate that meets the guidelines for production, weight and profile. So you are able to go back to production. The plate cut can be done B model ( pistols with a firing pin block), but we do not have a rear sight plate yet for that. The plate cut is not offered for the P10, P07 and P09 ( we offer an RMR BUIS sight cut, and can mill for specific red dot sight). We are working on Shadow 2 to see if this can be offered for that CZ variant. SP01 Shadow with the rear sight plate. RMR on an SP01 Shadow using the RDS plate.

Magwell needs some work with the longslide.

5.5 mm

USPSA says aftermarket hammers for CZ are good to go. You can do a lot on CZ for carry optics.

TS length match barrel in Shadow 2. about .5 inch.

S2 is AUZ barrel length. like 4.925. TS barrel is longer.

This comes in at 41.9 ounces with mag, DP Pro. so some room under the limit.