eerw
-
Posts
7,191 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Everything posted by eerw
-
75 Shadow is similar to SA frame upswept beavertail, amb safeties. SP01 Shadow frame has longer dustcover, small checker patches on frontstrap and backstrap and light bevel of magwell
-
From the factory. I would doubt it. and still no mag capacity. only 14-15 rounds.
-
With a MecGar AFC mag and the CZC pad, it will work with the UB magwell.
-
I found the scales kind of slippery as my grip shifted a lot
-
It has better fit that the CZC SP01 Shadow. has same hammer, but heavier springs 15 or 16#main, and 13# recoil. the CZC has polished internals, short reset and extended firing pin, that the Orange doesnt. if I bought an Orange. add 13# mainspring, extended firing pin ,FP spring and 11# recoil spring.
-
slide to frame fit , barrel fit is tighter than standard Shadow and B model pistols competition hammer, SS guide rod, grips and pads.
-
96214 has full adjustable rear sight, 91763 has factory rear sight
-
My conversations with Troy. If you take a 91254, 91255, 91256 or 91257, do a trigger job, do short reset, change sights and have the ACCU bushing installed. that is considered work allowed under the production rules and is legal. However Shadow 2 ACCU SKU 91763 ( and 96214 ) would not be legal under production rules because it is considered a new model.
-
. A Shadow 2 customized with ACCU is legal which is different from a Shadow 2 ACCU
-
-
The CZC micro are about the closest I have seen to the PT style. They are thin. But very grippy.
-
Nicely done. I like this setup better than the S2 configuration. But I'm probably in the minority for that.
-
We have done a few under the old rules. Optic cut and some other work. This is DP Pro which is 1.8 ounces, 23rnd mag. The DP Pro is heaviest dot we have found. With new rules, pretty straightforward to make weight. so should be pretty easy for anyone to do that work now. ( as I am sure you will see other begin to do it now)
-
Intended market will be IPSC production optics, no weight restriction, just need to be factory produced optic ready.
-
Here's and SP01 Shadow we did a high cut on, and a 97B we did a high cut .
-
should really be no problem in any of the fullsize mags. only issues I can foresee is -If too light a recoil spring, slide may drag on top round. -May be tough to load to full capacity. if running for 10rnd in Production. should be good.
-
CO was provisional. So rules changed and then made a division. Production is already division so rule change has a time frame to be in effect. something like that
-
yes the trigger stroke in DA is shorter with the trigger
-
we eliminated the screws. there is virtually no overtravel and we fit the top for the shorter reach and match a disconnector for it.
-
Haven’t measured the distance, but here is a photo of the CZC kit. works well.
-
send me an email stuart@czcustom.com
-
for clarity. CO max weight is 45ounce with gun, optic, magazine and pad. so S2 still needs a diet, but milling of the slide to specifically lighten is now allowed. Production max weight is 4 ounces over the factory listed weight ( with empty mag)
-
TSB has same dustcover cut as TSO , but the grip TS
-
I dont think so. not a legal production division pistol.
-
75 Bull Shadow is a model being offered. S2 Bull, Bull Sport, SP01 Bull are custom builds we can CO your S2 slide.
