I just received a 38/357 conversion for my 1050 and it has no markings, 40 Cal and it has nothing. I looked at them through a 20x loupe. I am hoping someone (Dillon) can give the hole diameters. Are your funnels for a 1050?
2% failure after using a GRX die?? Curious is it failing when you check fit in your barrel?? Have you isolated 9mm brass failure to 1 or 2 different headstamps?
Listen to Dillon.
Order the 223 convervion.
If you want to feed 223 from the casefeeder get the conversion.
The only part you do not need is the 223 powder drop.
Love it, IMO non spikey powder when you are looking for pushing projectiles that are heavy toward max pressure. I use it primarily for pushing 165 gr. Bullets in 9mm. It is a very versatile powder.
Iuse a dillon 1050,with no swaeging, and no belling in the powder drop, lyman mdie after powder and using ectreme plated 230 RN. My bullets seat as close to perfect as u can get with good neck tension. Thanks
I have a S1050 that I was not using and I am going to sell to a friend.
Anyway I can't figure out how the stock Acro bin bullet tray installs.
I figured there would be a million pictures on the web...I can not find one.
Even the manual show the optional metal bin...
Can someone post a pic of a 1050 with out the metal bullet bin, but the plastic Acro bin?
Nice idea but not possible.
I am reloading range pickup.
I suspect the issue is from an unsupported chamber. I will put up with it versus going with a the EGW U-Die which is supposed to be tighter than the factory Lee U-Die. I shootfew 46acp.
Running a Lee U-Die for sizing in a 1050.
Just dropping powder no belling.
I removed the powder check and installed a Lyman M-die.
Loading Xtreme 230 RN at 1.240 OAL
out of 100 rounds i get maybe 2 loaded rounds that fail Wilson case gage and the issue is a bulge in the middle of the brass usually. .473-.474"
I assume this is Glock'ed brass??
The issue is not with any one headstamp.
Is the only fix to use a Redding or Lee pushthrough sizer??