shooterbenedetto

Yes, housing can go up and down.I think so? as long as you got the plunger installed so that the mag release is functioning.

roller should be installed facing the front of the gun. it should also be relieved by filing the sides of it to make sure it makes contact with the trigger bar.

I have a question to add to the mount pattern question. Can anyone recommend a gunsmith who can mill a slide with the correct pattern to mount the RMR direct? Glockwerks does it. Call Ray and tell him I sent you. SB

I use standard CR speed with Daa pouches for my STI and Tanfoglio. It works for me. Only have one rig..

speedsec holster is great but it is plastic so it does wears out. after awhile, the block will crack but still works. It was one of my best holster before I switched to CR speed. Gun is also very close to the body and you will most likely would have to go to a hardware store and get a plastic spacer. You could also just get a Tanfoglio block for the ghost holster and just use that. Hope this helps.

nothing really special about it, but it would really be cool if you change the box to a rectangular shooting area and shooter can start with either end. I like it when I have a choice of how to shoot stages.

+1 but unless you really know where to trim off the sear and hammer(got two sets). Ask me how I know..but then again its how you learn these guns. If you want to learn gunsmithing, do trial and error and make sure you have parts just in case you screw it up. But if you want a drop in, get Henning's trigger parts with a few polishing and its good to go!

I hear 8.4 H6 1.190 is soft and great load! good to hear from you Jiggy..

why not just buy brazo's compensator? Bob has designed and worked on that already! Save time and leave it to the expert and just buy the brazo's comp SX.

+1 wait till you shoot it in a house window! I sometimes flinch(shooter) coz of the concusions.

Results anyone?

I'd like for him to do that with a great white shark! now that would be amazing! :roflol: :roflol:

Goog luck on the match..keep them clean and shoot it stage by stage. keep us posted.

Huh? with that big magwell you still missing to hit the reloads? i guess you would if its too fast!

Got lots of them if anyone interested? I think I have 6 tubes..

Already tried doing this and called EAA. There's no .40 with comp that they will sell you. they will asks for the serial number of your frame and they say that they can only sell you replacement parts for it PERIOD..if you want a comp, they wont sell it..they suck! other countries from Eaa will sell you everything, but here in US they wont.

Since zero ran out of their stuff I have switched t montana gold long time ago.

Shoot one targets at a time and count targets per shooting position. keep it clean per stage. if you are missing, then you are shooting too fast

AGreed, unburned powder is ignited at the comp. make sure you dont burn your scope!

I agree compensator on steel guns are mainly for the weight to minimize muzzle flip. No gas will work the comp.

You can tighten them by putting an allen key thru the Daa emblem. tighten the pouch at a 90degree angle so that when turned at about 45degree it will be tight.

i have had back pain all my life and lived with it. Im flat foot. DR made me orthotics. it helped. then comes MBT shoes..Best thing I have ever done. Go try one you will be amazed. it will also correct muscles involved in proper posture.

I know mecgar mags are for small frame Eaa witness. Is it loose? thinner in width? Order the factory and you should be good to go. I'm sure you can return that mag? Your Eaa is a large frame.

Tanfoglio is cheaper than CZ. look on gunbroker.

Please PM me. Need dimension on your mags. Thank you..