kaseyj5056
-
Posts
50 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Everything posted by kaseyj5056
-
For the last 3 years the mark 7s have caught my eye. Even the consumer model without an auto drive. They feel so smooth
-
Never had any issues with SPP. now adays they are a lot cheaper and run the same PF
-
a Czdchmate is not going to satisfy your needs lol. IT was a viable option until colt and CZ merged. 2011 is the way to go
-
Thick oil all day. If your 2011 can run on grease, its not tight enough
-
you need to replace it. You may also be able to get away with making it a SCSA gun and only shoot minor out of it. I would only recommend that if the gun has been looked over by a competent gun smith. Otherwise its trash
-
Definitely depends on case fill volume. I run 3n38 in 9MAjor so i load to 1.18 to make sure im not compressing the powder too much
-
A henning holster hanger will fix this issue
-
I think AA#7 is a good choice if you can find it. However it leaves a ton of unburnt powder (gravel). I load 3n38 in 9 MaJor with very little issues. A little spilling here and there but fine otherwise
-
As stated above, ordering the other basepads will work. Ive never had a Chrono officer even gauge my open mags
-
The 3n38 load makes about 174. Ive also used the same bullet over 7.4 Sillhoutte and 6.9 Autocomp with about the same results
-
I load 124 grain .356 Blue bullets. 1.175 OAL with 8.5 3n38
-
Ive tried many different powders using 147. My favorite loads are 147 FP Blue Bullets over 3.1 GR AA#2 147 FP Blue Bullets over 2.9 GR Titegroup
-
Blue bullets are the best coated bullets out there. Beware of Hitech coated bullets. They all smoke. Blue bullets uses a proprietary coating that smoke very little even in 9Major
-
MPA is going to be your best option for an OOTB GUN
-
wiebad fortune cookie. Sits flat for barricades but also curves for fences ect.
-
The b22 is a solid choice for the price but they are known for accuracy issues
-
Bourbon for sure, but im also from KY. Knobb Creek
-
Harbor freight mini mill and c more Mount
kaseyj5056 replied to duffdawg's topic in General Gunsmithing
Ive seen people do it with a hand drill. you CAN do it with anything. Is it worth messing up a $300 lower? Probably not -
Do you wear a respirator when you cast? just curious?
-
I think its about the same as dry chalk. Itll work, but it gets slippery in my opinion. Yes it dries your hands but makes them slick. Academy sells a tennis or racketball liquid grip that is the same formula used in most shooting specific grip enhancers.
-
That makes sense. I can trust a pole dancer backed product. lol
-
Ordered August 1st. Still no word.
-
Too big of a difference to compare. 507Comp is huge. I just dont prefer the dot options it comes with.
-
dont use chalk. It will gunk up your gat and make it more slippery than what it is with little sweat. A rosin ball works great if you can find one. If you cant then use pro grip or something even tennis grip
-
I have no relaxation. I try but as soon as the beep goes off its toast