eboadway

I had to remove material from that area to get positive resets. It would reset without a mag so I put it all back together and it wouldn't reset with a mag inserted. Removed more and now it's fine. My pretravel is about the same as yours.

Sure, let me know if Mr. Atlas doesn't have a few dozen!

School is open! Start reading! Lots of invaluable lessons to be had here.

I'm perfectly happy with mine. Screwed it in with Locktite, hasn't loosened up.

Henning has frame and upper videos at: http://www.henningshootsguns.com/tech/tech.tanfoglio.main.html These are for a Limited model but will get you started. The Atlas thread in the CZ forum is a wealth of solid information too!

TechNetArmory has one on GunBroker for $1099.99. There are 2 others on there as well.

That did the trick, thanks!

I run every round through the hundo. The few that don't pass go in the practice box. Takes only a minute!

I love having new tools, but this one made me say "Huh?".

Please join me in Vermont. I can't imagine waiting 4 months for a gun, not being able to shoot target arrays at the range, etc.

Sorry, 1 piece.

My SA and DA function after fitting the T3 disco, but the SA won't drop the hammer after being reset by racking the slide. File the top of the wing a bit? Thanks.

Truth. I took an SP-01 mag to the LGS to confirm what others' had said. If it had fit I would have bought the P09 on the spot.

Well the 75b IS a fine handgun...

Hell I'll make that trade It's a great deal and I'd be happy to see Mr. Atlas take advantage. PM'ing you sir.

I'd like to trade thin, black aluminum grips (taken off when new) for CZ rubber grips. Any takers? Or I could offer $. Thanks! Ed

Any word on interest for the holster? Thanks.

That's the video is learned on, but put your frame in a vice for the swap. Frees up a hand!

I also decap then wet pin clean. But I'm uptight and enjoy the extra step(s) once I see that sparkly brass!

Would a couple of coats of spray paint be too ghetto?

Do you have a large frame Stock II? If so, the Springers will not fit. I have them for my CZ and they are great. First thing I tried was putting them on my Stock II mags which (of course) was a disappointing failure. I bought the Shockbottles and really like them. The finish matches the frame really well.

I'll have to try that load. Right now I'm using 180g Extreme's at 1.14 with 3.4 grains of Titegroup. Plenty accurate, but a bit sluggish as you mentioned...

I use this as well. Very soft shooting with minimal recoil, although TG is a pretty dirty powder.

I use the new toolhead stand.

The primer bits should have been included with the original purchase. Did the first owner not have them?