Wideload

1st Venom failed little over 10K. 2nd is the replacement from Vortex and it's still running.

Similar experience on durability. Have one (for "Practice" and local matches) with over 20K+. It is currently set up with Apex trigger, tungsten weights glued into the cavity inside the back strap, Vortex Venom and Streamlight tlr-1. I believe it weighs 35+1 oz unloaded when using Henning's +3 basepads. The "match gun" has 12K+. It's set up with Apex Trigger, TLR1 and CMore RTS2. It also has the Brass backstrap from Taylor Freelance and that gets the weight to 38+ oz.(Almost as much as a SP01) I run 135 grain coated bullets.

I can get 19 in. I can get it to seat with some effort but, it will not feed properly unless I cut a coil off the mag spring.

Primary Machine did a CZ P09 milled for a Vortex/Burris pattern for me few years back. I believe they have recently got out of milling Customer provided slides. There are others that still provide this type of service. I think the challenge with the CZ slides that have the firing pin block is that you cannot have the Optic milled as low as slides without fpb.

Take out the magazine brake (part #24 in CZ manual),flatten it out and put it back in.

Number of Stages? Round Count?

Yes, would definitely consider driving down from KC.

You will want to check the total mag length with the extensions. Some of the polymer extensions are invitation into Open.

I believe so ... But, when I ordered the pads couple years ago, the CZC site recommended a spring and follower to go with the pad for maximizing capacity. While their site no longer provides that function, the image and description matches what I got.

CZ Custom Basepads with 10 coil spring and follower setup will get you 23+1. It will not lock the slide after last round. (Originally set up for P09 Carry Optics gun)

Thank you to Shana and everyone that made this match possible.

Just run the 19 rmr in open at couple local matches and compare your scores against othe CO shooters. If you like it enough, you can pick up a g19 lower or build a dedicated CO gun on a full sized frame.

Burris FF3 8moa. Lifetime Warranty and cost.

Will it be available in .40 with Single Action Only Trigger?

New Fixed Sights 1mm f/o front/plain black rear Check to see if the newer mags fit it. Then shoot it for a while before deciding if you want to put comp hammer and other stuff to it.