eerw

oh..got yeah. let me check something.

Couple of choices http://czcustom.com/cz-parts-all/front-and-rear-sights/rear-sights/p07-p09-rear-sights.html you guys hurt my feelings

barrels are not stainless. some come silver, some come black.

Frame still takes the small mags, so not enough capacity.

will depend on tolerance of pistol. cut of frame, thickness of polycoat that CZ applies, have not seen one require fitting in a long time.

this pistol was built by Jimmy Vidanes of 1911 Speed Shop out in California. He would be best source of pricing. The base gun was a CZ 75B SA 9mm pistol.

sights are blued, trigger is anodized, other parts were sent.

This is the build I have photos of with H&M black nitride. We did the ACCU bushing on it.

We have used H&M metal processing.

Photo? Slide on frame where stops Lower from top, so can see ejector housing, safety, etc Thanks

cool photos... so when were the changes made. to the smaller C-more red dot, trigger shape ( to the flat trigger), sear/hammer?

Nice work!

In the US, it is supposed to ship with the nickel plated 17rnd magazine. Other parts of the world its been shipping with the MecGar AFC 19rnd mag. otherwise SP01 mag, 16rnd mags fit also.

yes. remove FPB from slide replace lever with spacer or use pre B sear.

LOL TSO was a 2016 introduction.

CZ-USA facebooked 2017 for the SHADOW 2 CZ-USA Coming to the US in 2017, the Shadow 2 is sure to decimate in USPSA Production Division. More than just a tuned-up version of the SP-01 Shadow, the Shadow 2 is a new gun from the ground up. " CZ-USA - We'll officially release it at SHOT in January, so order fulfillment will begin sometime in early 2017. Thanks!"

Thanks The safety on the Shadow is a welded up version done by Jim Milks at Innovative Custom Guns. He did this a few years ago.

I like the magwell as it helps position my hand higher on the gun. on one of my open guns,and a limited minor gun I shot for short time.

Techplate

mainspring plug pin will hold in place. Have magwell on two guns, tight fit, no shifting. some fitting may be needed. but pretty easy to install. no screw in plug to loosen up, etc.

easy peasey... a good action job with get the DA smooth and easy to pull, and get the SA release crisp.

My other gun is a little less mass up front, but even over the years of shooting full profile vs small profile comps of different materials, there is a balance that you seem to find. but it still seems purely up to the shooter preferences. but that is all an opinion The comp actually has a lot of metal out of it for chambers, recoils guide running underneath, etc. so really not that much mass out front.

Nice work!

Install with lockplate and pad

Tube length is different on the 16 mags from the 10, 15, 17 mecgar mags and the lockplate has a different pin location.