echotango

I don't have a pair. Wanted to find out prior to purchasing. Appears more like a fiberglass than a plastic/polymer. I'll pass. Going to make my own as I am looking for a flat grip.

Anyone know if you can stipple G10? I would like to replicate my stippled 2011 on a 22/45.

I have a steelmaster that would stovepipe with an upright mount(even sent it back to sti, played with ext/eject, installed an aftec). Tried a 90 and removed it immediately. It was not for me. I installed a cheely offset mount and have yet to have a problem. you don't even notice the offset.

As whitefish said, some stages require reloads and some at certain points(sometimes mandatory) to where a 170 has no benefit and for me a 140 is easier/faster to load.

Same here. 170's all the time unless a stage benefits with 140's.

They now offer a 8moa rts2.

No problems at all, they ran perfectly. I just prefer the glass size, dot size options and brightness of the railway/slide ride.

I just switched back to slide rides on 2 open guns from RTS2's.

Nevermind. Figured it out.

I agree. I called them and told them to never mail me a cat again. I have the SC discount on my act but have not seen a discount yet. However I order from them all the time. You can get serendipity's cheap on GB. Very easy to convert.

Email c-more with your ser # and they will tell you what you have.

I use the STI ext. I also do not have to adjust my grip to change mags.

Maybe tack on some weld on a stainless ice and grind to fit.

just got 16# of autocomp.

I also had to re-zero every time.

I didn't like the glare shield either. Unless I was exactly centered, I would loose the dot.

I use a 6 & 8 for steel only. Tried a 12 & 16 and didn't like it.

But it is offset. I have that one on another gun already. Looking for a non-offset. Thx

Thx, I could always go that route.

I'm trying to find a black C-More mount(not 90) in black without having to get it anodized. I could only find airsoft versions and not sure of the quality, hole pattern or fit(height/width). Appreciate any help. Thx

Shooting a shorty now. Just ordered a 5". Will sell the shorty once the 5" is done.

Good basic info. What was the offset between the center of your optic and your bore?It is a Fastfire III in a Burris F3 mount on a m&p15-22. I think the standard ar height.

50yrds zero w/40gr blazer 7yrds - 2.5" low 11yrdr - 2.5" low 20yards - 1" low 25yards -0" 40yrds - 0" 50yrds - 0" 75yrds 1.5" low 100yrds - 3" low

15yrds, steel only.

Thx. Going to give that a try.