Kingman

Pick up a Medford once and you will know. We are dealers for many many higher end pocket knives. I will Only sell what i truly Believe in.

We have been selling a good number of the Cheely E2 grip in stell and aluminum. Steel adds the weight and texture, while aluminum adds the texture, it may be a bit heavier. I have now put 3 on various 2011's for friends. So far they have fit right onto every STI frame we have worked with. The only part that needs fitting is the beavertail around the tangs on the back of the frame. Technically you could go without fitting this, but I wouldn't. They have a great feeling to them, and the weight is pretty nice since it is right where you typically want it.

You can step up the Dawson or Techwell, both are about the biggest on the market that still will fit.

Ok. Will need one. Very interesting how some companies are targeting competition type builds more.

Changed some trigger guard widths also.

Nice. This gun is one of the hardest to get a good mold on.

Thank you

Thanks guys.

Sorry. Not on here often. Yep. Order with the threaded barrel option and we open it up. We then clean it all up nice.

Yep. Pretty amazing pistol in 9mm.

Tighten the bottom screw until its 1/8". That will be we're it touches the gun. Then adjust the top screw for retention

Thanks everyone. Yes ours will shave off some. It is the nature of why we do what we do. We use many guns in the building. I'm sorry but I'm not filling a $1500 gun with epoxy to block it out. So cocking serrations etc will shave. I have started including very very clear directions on adjustment. There has been one holster come back that didn't get fixed with actual correct adjustment. Our spacer is 1/8". All holsters need adjusted 1/8" approximately at the bottom screw. This is difficult for most as I use 1/4" rubber washers so they don't wear out. If you have a problem send it back. I'm happy to look. Its interesting how negative 1911builder is, yet I don't recall anyone returning two, but since it's anonymous profile I can't check.

We are a forum sponsor and make many holsters for most cz firearms.

Ok. Sorry been swamped on the business end. At area 8 all this weekend. I'll get it Sunday.

What do you need on it?

Well. It's a bit more off the top of the slide

We have one and are making holsters. This is one of the nicest guns sig has made. Pics are on favebook www.facebook.com/redhilltactical or on instagram @redhilltactical

I have 6 guide rods left in stock also.

Use the PT block in the alpha x

We have models that start at $36. I'm not sure I'd want to use it seriously competing, but it does work.

Ok. So had an idea. But need to find one of the old bianchi shrouds Tanfo used to make. Does anyone have any ideas of where to look

Hi guys, I know there has been some question as to our lead time at Red Hill. In order to meet demand for these guns I just ordered a second X5 to mold from. As soon as it gets here we will begin pushing them out. I have also hired a full time employee as well as the part time guy we have had. We have a goal of being able to offer a same week shipping option.

We have started shipping x5 holsters at this point in time. Some things to take note of 1. The older 320 will fit into the x5, it is not a great fit, but serviceable should you need a back up. 2. The x5 does not work well in the older 320 holsters. Yes you can cut the end open or use heat and make it work. Again it is serviceable, but not optimum.

Sorry guys. I've been swamped and not on often 301-707-7972 text me.

Without Thumb rest. Funds have already been refunded.