Jump to content
Brian Enos's Forums... Maku mozo!

Amra86

Classified
  • Posts

    70
  • Joined

  • Last visited

Everything posted by Amra86

  1. I like it so far. I only have about 50 rounds thru it zeroing and chronoed couple loads to see where the barrel speed is.
  2. I ordered mine on May 4th. I received it Dec. 1st.
  3. I had a Faxon 18 inch rifle length barrel. I had to open up the gas port to get it to run right. The gas port in the barrel was too small. Faxon gas ports are on the small side in my experience.
  4. The 12 moa would be better for steel challenge.
  5. The EGW dovetail mounts work well.
  6. DSS and Crooked Creek, you can find them on Practiscore.
  7. Major open shoots flatter and faster than minor open. I would still shoot major in my open gun even if scoring was the same.
  8. Infinity or McLearn custom guns.
  9. It is within driving distance for me now. I wouldn't have the cost of a flight and rental car.
  10. I modified a CZC extended safety to give more clearance for my week hand.
  11. 124gr PD JHP 9.4gr 3N38 1.235 oal
  12. The optic mount might be moving. Make sure the mount screws are tight.
  13. I believe the 9mm breach face is too small for .40, you would need a .40 slide.
  14. I have a Czechmate with 9lb recoil spring. It will run Speer Lawman 115gr factory ammo just fine.
  15. I seperate out CBC and SB cases. They seem to have tighter primer pockets and thicker case walls.
  16. I order mine March '21 and haven't received it yet.
  17. Getting to groups sounds like you are double tapping instead of seeing to sight pictures.
  18. Amra86

    223 powder

    I would choose Tac as well.
  19. In a major match you might see 1 out of 10 stages with strong or week hand only. I will shot 10 or 20 rounds each hand when I practice. I will usually shot between 300 and 400 rounds total on a practice day.
  20. I run the factory firing pin.
  21. The factory spring should be 20lbs. I have over 13,000 rounds on my original spring. It still sets off SPM primers no problem.
×
×
  • Create New...