Ck867

I would imagine most people aren't going to run out and change their hammers. The CZC works just fine.

Does anyone who shoots USPSA use the Dawson IPSC magwell? I am also curious what magazine/pad combo works with the IPSC magwell.

Has always been a very consistent powder for me in a Hornady LNL.

They slow me down but that is because I am not use to it. Once you shoot with one regularly then it will be faster.

I don't think the Scales is larger than factory rubber and the LOK is about same size as the rubber.

Ask your club to use Pend or Pending as your number. I did this when I first started and the classifier showed up after I was assigned a number.

Looking forward to trying a new option!

The way that slide is milled does appear to be an issue on the optic staying in place. Here is a pic of my cz slide that I had Springer Precision milled for a Deltapoint Pro. The optic sits very tight on the slide and the screws are only there to hold the optic in place. Optic has not loosened at all after 1k rounds so far in test fire.

when are these being released?

Thanks! Is a new spring needed?

Does this look correct? http://benstoegerproshop.com/xtreme-eaa-tanfoglio-firing-pin-block/

cheapest place to buy the extended firing pin block with shipping?

It's usually never worth it unless you are a high volume player.

Looks great! I want to do this to my xtreme. Part of the grip area is starting to rust on mine.

I wish it was the prone stage also!

amazing! Didn't know they still sold wolf primers?

I prefer the czc aggressive for the flat grips but the Lok grips are very aggressive also. It may come down to preference on what texture you want.

It was natural for me and only took a few months...but this was before i started in USPSA.

So for the higher volume shooters or those who dry fire a lot, are you changing the TRS for preventative maintenance?

1. I sent mine to Springer Precision for the milling. They mill further back compared to CZ Custom. Cost was around $160 for milling and cerakote. Took about 5 weeks to turnaround for me. 2. Issue seems to be milling further forward on slide close to the extractor. 3. I found mine to be decently low. 4. I just had mine done and have limited experience. 5. No sights on mine. I'll be at Richmond on Sunday for the match if you would like me to bring it to check out. I have only shot it once at a classifier match so I have very limited experience with it.

It's pretty likely that you will need the extended fpb once you change the hammer or FP.

I would say the tanfo has been easier to work on but I do find changing the hammer spring on a cz more simple.

Every 5k ish.