newmexicocrawler

As said before Head, arms, legs Easier said than done I know

Yes they have off days....its just someone doesn't notice there bad days as much because there bad is still good

SWEEEEEEEEEET that's how to load ammo

How did these work?

I wet tumble when they are done I use the tumbler media seperator then spread the brass on cookie sheet and in to the 200* oven for 10 min pull out shake and 10 more and I'm done

What size and teeth count are you using?

Thank you for the link....didn't know they made them. Just ordered one and will give it a try

I am lucky....there is a shop here in town that has powder in stock 1lb to 8lb for around 27 bucks a pound out the door

I use them on all calibers in one way or another and have figured out how to set them. Once you learn how to set them up and get them set right they work just fine

I took a Lee resize die and ground the open end down to remove most of the bevel now it goes all the way down the brass to just barely above the rim. Then on 9 and 45 I use the Lee factory crimp die in station 5. On 40 station 5 is empty and I move all the loaded rounds to the single stage press and push them all the way through the factory crimp die that has all the crimp inards removed so the bullet only gets pushed on the outside and it gets pushed all the way through the die collecting on the round die case from lee

I have used Rudy red but ended up going back to just plain old clear glasses

I have been catching up on the power factor show

I have had one primer that loaded into the tube and went in about half way and got jammed....had to almost beat it out

That dot drill is a good drill....I do it from time to time

This is good info......I will have to start doing this

I was at a match a couple weekends ago and there was a revo guy who shot every stage with a lit CIG hanging out of his mouth

I look at the magwell.....I don't hold finger on the bullet tip I just bring the mag up and push it home

This is in my future....Dr wants to wait and see what my eyes do, where they end up since it only been wearing glasses for a year

Ok....that I can see and agree with It is a simple part change and I change mine out when I switch between the calibers. The "ejector" that is, I use the same "extractor" in both calibers.

OK why is this? How can a ejector (or extractor) set off a primer?

I'm not sure how to feel about these (IF they are true)......I am not a fan of optics but I am a fan of long slides. I too would like!e to see a single stack 9 and positive it will be released soon and will be same exact size as the 380

I have a couple in idpa stage designer......I'll look them up and send you some

This is a awesome idea......good way to get a butt load of good stage ideas

I don't load while moving right to left because I have seen the 180 broke to many times...better to take a couple extra seconds to reload after moving than to pack up and go home

This is something to think about every time you toe the line