Ryan, what bullet is it, the 180gr # 40040 HP/XTP,40042B HAP,#40047 FMJ/FP ENC or is it for sure the #10808 SWC(discontinued)? Looking at my manual the 180gr swc measure is looking like it is hot! But I trust what Grumpyone is saying.. Now according to your manual the O.A.L. or the C.O.L. Is to high, bring it down to 1.125 or closer to that and your roll crimp in my opinion needs to be atleast .420 or enough to to remove the bell. Same for your copper jacketed bullets! I hope this helps! I did the same thing when I loaded my .40 cal reloads... Again invest in more manuals to use for reference! That should work! Make a dummy round don't deprime/resize it put a bell on it(dump the powder in the hopper), place your bullet in the belled case and seat your bullet till you get that proper seating depth(1.125)once you got it at the right depthpull the lever down then tightin the seating die, the go to the crimp die and pull the lever down and role crimp it! If it has not takin the crimp out it might be touching in you barrel and that little hair width of a crimp does matter! So keep lowering the crimp a notch till you got it set(.420) then tightin the die and measure with your caliper! You might have to pull it a few times!