Loves2Shoot

Send me an e-mail and we can make some for you when we run our next batch.

We do more "Open" guns for carry than competition. Maybe they are waking up.

Yes, but not cost effective.

How about now?

Do the photos show up?

IDPA DOT 5.25

EDC RED DOT

It was my understanding you were wanting the letters in their logo font, simulating their logo.

Sorry, but we can not engrave CZC on our CZ products. It would infringe on CZ Custom's trade name and branding. If those are your initials, hopefully we can make other accommodations for you.

Thanks, so This Product should be legal for SSP, since the weight of the original metal baseplate is removed? 8.2.1.3.18. Aftermarket magazine base pads may be used provided they do not make the magazine weight more than 1.00 oz/28.3 grams over the same capacity factory magazine. Correct

We have no interest in machining TC.

16's weigh .1.17 OZ 17's, 1.056 and 18's .61 OZ

If you want to send me some red tape to cut, yes. We are a bit out from adding colors, as the colored tapes we have found don't perform as well a the tape we use.

Get your draw to an A at 25 yards to 1.25. Point shoot draws aren't skill builders, but they look cool.

typo 12K

I have 2 and wouldn't want to be without them.

And there are the people in restrictive states. We will get one done, just not for a bit.

I just added a 12000 rpm 800 IPM 1400 IPM rapid machine. Suckage is relative to what you get used too. Once you are used to faster, everything else seems bleh.

Demand for XD magwells is very small. I'd like to make one, but it is not high on the list right now.

5+ OZ

So true. There is no limit to cool things you "need."

I don't think you will be happy with the method you are describing. If you don't want to do good prep, you won't get a good finish. The air cure is not very durable compared to the heat cure.

http://shop.springerprecision.com/category.sc;jsessionid=4E017B669EC5C99EDCC43AE27963D2D0.m1plqscsfapp05?categoryId=6 Lots of IDPA stuff here.

Not strong enough wouldn't go to slide lock with factory follower but would feed the last round. For lock back, you will generally need the extra coil springs, but generally they feed without them unless they are really week. We have springs and will have a follower soon that will have lock open capability and will add a few extra rounds.