Jump to content
Brian Enos's Forums... Maku mozo!

kalebg

Classified
  • Posts

    64
  • Joined

  • Last visited

Everything posted by kalebg

  1. Remove the primer tube and primer slide bar, you may have a primer cockeyed in the slide bar...or back off the Allen bolt on the primer lever located on the primer tube....slide the assembly up and check to make sure the primer slide bar isn't stuck...you can also remove the the plastic locator tab on station 3 to get a better view of the to the primer slide bar...before you reinstall anything, make sure that the primer slide bar moves back and forth completely and smooth as glass. A stuck primer, stuck slide bar or dirty priming system will prevent the machine from cycling completely/ smoothly. Good Luck, don't pull your hair out...
  2. Production 3.22....40 points....HF 12.4
  3. Leading is an issue everyone talks about but is never an problem with a high quality cast bullet. If you only shoot a good cast bullet, don't worry about it. If you shoot a combination of cast and jacketed, scrub the barrel before you run any jacketed through it. But, even if you forget, it's typically not a problem. You just end up cleaning the barrel without the elbow grease. I have at least 10k through my shadow and have never cleaned the barrel. I scrub the chamber to ensure consistent feeding...no more. Yes, it's polygonal rifling. Yes, they smoke. If there's a breath of wind you'll never notice. No, I have never seen a decrease in accuracy due to not cleaning the barrel. I have videos posted here: YouTube.com/kalebg35 and even in a hot, humid climate like Arkansas, smoke was not a problem except for two targets on "the door" stage. Practice or matches, I only shoot cast bullets and I get them here: shooterready.biz Hope this helps.
  4. I use solo 1000, WST, or hp38. My CZ hasn't had a brush through through it in 10,000 rounds. PM me your addy and I will send you some samples.
  5. Shooters that experience high leading in polygonal barrels are using crappy bullets. I only shoot cast bullets; practice and matches. I have never had a problem. Give these a try: JD Sales 806 676 0017 shooterready.biz
  6. kalebg

    Shadow Sights

    I run a .90 wide plain black dawson
  7. I am headed to DFW tomorrow and will be there til Wednesday, then its off to OKC til Friday morning. I have to work during the day but am looking for a range/shooting buddy after work. If anyone has any suggestions or would like to bust some caps with me, please let me know. Thanks, Kale Garretson 806-392-1771
  8. kalebg

    cz po-1

    no worries..most people don't have the opportunity to try and see..and most folks will get the answer that it is not possible. cuz really its not intended to be that way. it is not optimal and I would not recommend it. but you can make parts fit and get it to work..if you HAVE to Thanks for the info. Not worth it
  9. kalebg

    cz po-1

    Is it possible to convert a PO-1 from a decocker to a standard safety?
  10. I try to shoot a major match on Friday then catch a club match or two on the way back home.
  11. be patient...it comes with time and practice
  12. I've had quite a few Tech Wear shirts. They are always top quality and they do a lot for the sport. Don't know about the other guys.
  13. I've had the same problems with my CZ....140 grain and 147 grain cast bullets tumble with Solo.... I have switched to a 130 grain cast and no problems You can find them here...My link
  14. Sick....Otta run like a champ
  15. Gotta see this one, looks good
  16. I have an olympic in .40, what a blast, no earplugs....a .22 is next
×
×
  • Create New...