vgdvc Posted December 6, 2018 Share Posted December 6, 2018 29 minutes ago, GringoBandito said: Because I have big hands and the right hand safety would dig into it and prevent me from gripping the gun very high. Once I replaced the safety, I was able to grip the gun about a 1/4 (if not more) inch higher which gave me a better grip and control of the gun. I see. Everybody's body mechanics and shapes are different. Good thing we have choices for different needs, thanks for the response. Link to comment Share on other sites More sharing options...
scooterj Posted December 6, 2018 Share Posted December 6, 2018 I also have large hands and have to remove material from almost all ambis so the knuckle of my strong hand doesn’t engage the safety while firing. Link to comment Share on other sites More sharing options...
Joe4d Posted December 6, 2018 Share Posted December 6, 2018 A vote for none of the above,,, Have ZERO use or desire for an ambi safety,, they are exposed and more likely to get flipped down while holster. They are in the way and more likely to get flipped UP with your hand while shooting. No stage can require u to draw with your week hand so any left hand engagements are almost always transferred from right hand. In fact have NEVER seen any stage where a ambi safety was the least bit beneficial, and lots were it was detrimental. If I was left handed I would still figure out a way for a right side only safety. Link to comment Share on other sites More sharing options...
muncie21 Posted December 7, 2018 Share Posted December 7, 2018 3 hours ago, Joe4d said: A vote for none of the above,,, Have ZERO use or desire for an ambi safety,, Amen to that. Literally just got done fitting a single-sided safety to my SV,, as the right side ambi dug into the knuckle of my strong (right) hand. Link to comment Share on other sites More sharing options...
furyalecto Posted December 13, 2018 Share Posted December 13, 2018 Has anyone seen a CKArms ambi shielded safety on a piston to see how high it goes? PT is a little tall. Link to comment Share on other sites More sharing options...
Posvar Posted December 13, 2018 Share Posted December 13, 2018 I saw mention of the weak side safety getting flipped up while shooting. All the 1911/2011 guns I own I ride the top of the safety with my thumb which would make this impossible. Is this not the norm? Perhaps those with smaller hands can’t reach or grip that way. I’m curious as to who else does this. Link to comment Share on other sites More sharing options...
cconnection Posted December 15, 2018 Share Posted December 15, 2018 Are you a Lefty? As a lefty you have to have ambi, and very few have large on right side, SV does, typically they put the Tactical length on right side, not enough volume to rest thumb on. and the shielded safety are not to keep you from getting bit, but to keep those who ride their hand high from slowing down the slide and causing malfunctions. When you are running fast you will not even be aware that your thumb is riding the slide. I had several malfunctions in one match early in my shooting life, and an older wiser RO pointed that out to me. And I realized my training had recently had me push my grip up higher. Link to comment Share on other sites More sharing options...
SJan Posted December 17, 2018 Share Posted December 17, 2018 On 12/6/2018 at 5:18 PM, Joe4d said: A vote for none of the above,,, Have ZERO use or desire for an ambi safety,, they are exposed and more likely to get flipped down while holster. They are in the way and more likely to get flipped UP with your hand while shooting. No stage can require u to draw with your week hand so any left hand engagements are almost always transferred from right hand. In fact have NEVER seen any stage where a ambi safety was the least bit beneficial, and lots were it was detrimental. If I was left handed I would still figure out a way for a right side only safety. I was on this boat, until during a weak hand required string my knuckle bumped the safety up. Now I run ambi that is heavily modified on the right side to fit my hand during normal freestyle, but is still enough to ride my thumb on during weak hand only. Link to comment Share on other sites More sharing options...
scooterj Posted December 21, 2018 Share Posted December 21, 2018 On 12/12/2018 at 9:44 PM, furyalecto said: Has anyone seen a CKArms ambi shielded safety on a piston to see how high it goes? PT is a little tall. Just finished fitting the safety. Took about 5 minutes with a fine file. Link to comment Share on other sites More sharing options...
furyalecto Posted December 21, 2018 Share Posted December 21, 2018 Looks good. Thank you scooterj! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now