Is there a PCC that takes 2011 mags?

[bluesman2a]

I heard some buzz around new PCC's coming out at shot that would take 2011 mags. Does anybody know more about these? I know that Nordic has put out their offering that allows for changing the magwell, and they have hinted that 2011's are to come, but is there anybody else out there I should be looking at?

[Aircooled6racer]

Hello: I am not sure if the 2011 mags are the way to go or not. They are more costly than Glock, M&P, SIG or Metalform/Colt ones. They do have a nice taper to them which would help with reloads though. Thanks, Eric

[OPENB]

And you'd want at least a 32 round capacity.

[JHOWARD]

I am pretty sure it's Wilson, but I don't know that the magwell is out yet.

 

[frag316]

You could go with a Mechtech upper mounted on a 2011 frame.

[DocMedic]

Nordic is putting together a modular magwell system on their PCC guns, Jesse T has stated they will build a magwell for 2011 guns...

[al503]

6 hours ago, Aircooled6racer said:

Hello: I am not sure if the 2011 mags are the way to go or not. They are more costly than Glock, M&P, SIG or Metalform/Colt ones. They do have a nice taper to them which would help with reloads though. Thanks, Eric

They are definitely more expensive but many already own them.  Another disadvantage would be capacity.  With glock mags with the right extensions, IE, you can get over 40 rounds.  With a 170mm and a plus 2/3, you'll most likely get only 32-33 rounds max.  Probably wouldn't make a difference in 90+% of stages, but...

[Aircooled6racer]

Hello: I have a base pad setup for 170mm mags that will hold 34 rounds. If Nordic make a lower that fits 2011 mags, I am sure someone will make a base pad to get the round count up to 40. Maybe even Nordic? Thanks, Eric

[chuckstur]

I had to make my own.

[cferree]

Take a look at this one from Trojan Firearms:

https://www.gunsamerica.com/blog/uspsa-pistol-caliber-carbine-takes-stiglock-mags-trojan-firearms-shot-show-2017/?utm_source=email&utm_medium=20170118_SHOT17_2&utm_campaign=/blog/uspsa-pistol-caliber-carbine-takes-stiglock-mags-trojan-firearms-shot-show-2017/

[RigPig]

49 minutes ago, cferree said:

Take a look at this one from Trojan Firearms:

https://www.gunsamerica.com/blog/uspsa-pistol-caliber-carbine-takes-stiglock-mags-trojan-firearms-shot-show-2017/?utm_source=email&utm_medium=20170118_SHOT17_2&utm_campaign=/blog/uspsa-pistol-caliber-carbine-takes-stiglock-mags-trojan-firearms-shot-show-2017/

Want. I'll be keeping an eye out for this one. 

[mreed911]

14 hours ago, chuckstur said:

I had to make my own.

Now that's funny... well done, sir, well done!

[Shepard]

I'd like to see a lower that takes 2011 mags as well. I think PCC two gun is around the corner and I hate glock triggers. 

 

[chuckstur]

Thanks, but my advise is to buy one at any cost.  Way too much trouble to do it yourself unless you have a CNC mill.   The (.40 cal) 40 round mag is a hoot, though.     

[Mulligan03]

Trojan firearms