revoman

Can you find a picture of it? I looked and could not find

Not left handed and I made it a little long to start with so I can adjust down in size. A little easier to remove length than to add. With this release your strong hand grip never changes if you reload weak hand style.

60981227619__646CC3A6-3484-4485-BB99-03024794B7AE.MOV

Modeled this off an old friends works like a dream. Installed spring kit, shims and polished insides trigger at 6.5. Now I just need to get Hogue Big Butt grips and it is ready to go.

I have a 625-7 PC with the 5 1/4” barrel. Used to have 2 of them and wish I had never gotten rid of it. I think that it actually moved better than the full lugged barrel on a 625. You can find the 4” version all over but the 5 1/4” is not likely to show up anywhere.

Just giving you a hassle as I did the same thing except I had a 38 super cylinder. Never have used it but it is there if I want. I did have to have the .357 cylinder cut down to the same length as the 38 super and extend the forcing cone.

Could have accomplished the same results with 38 short colts. Just saying

Unless you are sending the part such as the frame or receiver that has the serial number on it. Then it is just parts. Best I found is to take with me a copy of UPS or FedEx rules for shipping firearms that way when you encounter a anti gun or a misinformed clerk. Pop out the company rules and federal guidelines. I also do this when I fly with a firearm saves a lot of hassle

Must be a web site problem as I am a life member and I see the same thing

https://forums.brianenos.com/topic/225481-new-90-degree-revolver-mount/?tab=comments#comment-2512677 Try this. No change to draw

Does fantastic work

Call TK Custom they might do it and try Pinnacle Custom. I can’t remember the place but it is some where in Texas I had a Ruger 45LC that all the chambers were different and he cut them all to the same. If I think of the name I will send it to you

I now have on mine Alchin 90 degree mount. The lowest one out there

Pinnacle Custom will build whatever you want

Simple fix on the white outline use a magic marker or sight black

I find that most of the loads I use in 38 short colt reach power factor with shorter oal. Try the Tightgroup at 2.9 and oal at1.160. My load I use is 3.4 VV320 and oal at 1.180 power factor 132. 160 coated bullet using different brands

Can I get a picture of the bobbed hammer

If I was you I would go back to sporting clays as your revolver pattern looks like a shotgun pattern. In fact I think a shotgun pattern is actually tighter.

If you are doing this then you are jerking the trigger instead of pulling.

Are you gripping with your strong hand or weak hand? I find that if I grip with my weak hand my groups are smaller than if I grip with both strong and weak at the same time. Also if I only grip with my strong hand and just place my weak hand over my strong hand my groups are still larger. This works for me.

I will let you know in about a week

Buy the new Ruger 8 shot 9mm and with the steel cylinder should not have a problem.

How were you reading your scale and where was the decimal point?

147 grain bullet VV N320 3.9 grains 978 fps according to their books. If he was using grams and was thinking .310 was 3.1 grains that put him at 4.9 grains. This would give him a compressed load. This is what he had to do as the formula I used early filled up the case and half my powder pan.

Works out to 3.1 x 15.432 = 47.8 grains. I don’t think you could put that much in a 9mm case.