Joe139

The only thing is with the X-die you trim your brass (and don't quote me look at the directions)like .010 shorter than normal trim length then it pretty much stays the same and it does work, So make sure the brass you buy is trimed short enough or you will still have to trim it again.I had one but now I just trim it a little shorter and use Redding dies.Just a heads up hope this helps you. Joe

I think that is what Limcat puts on there grips maybe you can ask them.I ordered a gun from them and I think that is what there putting on mine they asked what color I wanted I'm going with black but I'm sure they have blue.

I don't think you can go wrong with a Dillon or RCBS I have both digital and beam If you get a digital don't get a cheap Ebay model get a better one like the Dillon or the RCBS they work pretty good.

I run a 17 main and a 8 recoil spring in my open gun 38 SC

I used a shock buffer in my Colt 1911 but in my 2011 Sti Limlted and open guns I don't. It depends on the gun

So with all that said would you suggest a 17 or 19 Lb spring I use a 19

I zero my gun at 60 feet with horizonal C-more.

I use a ambi safety (Infinity wide) and a Dawson one piece guide rod in my 2011,Just my opinion.

I ordered a Razzercat from them in November talked to them a couple times since I usually got a hold of them around 8:00 PM eastern time I usually had to call a couple times

How ever you build it make sure you fasten it to the wall so it don't shake around when you run your press.

That is what I use is a 124 gr Montana Gold 9mm bullet in a 38SC. My barrel is a .355. I think a 38sc is suppose to be a .356

My C-More had a haze on it it was not clear I tried lense cloths didn't work I tried acytone I heard that would clean it it didn't so I read some where to clean it with Limeaway so I tried it with a Q tip it came out crystal clean took all the haze off of it it looks like new.

After reading a lot of posts I went with a Ghost holster C R Speed pouches and a DAA belt and it works fine for me.Its nice you can mix and match.Just my 2 cents

I also like Gans work. They have my vote

Thats good to know

I also say go with the tuned Edge Dawson or Brasos either one

Mike, Your gun should run fine with factory mags and factory ammo or send it back and get it fixed period.I shoot matches so I bought some tuned mags for piece of mind and my Edge shot Regular Blaser ammo fine to,Joe

So the 38 SC barrel they sell is it .355 or .356 I was told to use 9mm bullets in it 124 gr MG JHP is this correct

I had a Brasos tuned Edge it ran any mag I put in it a little more money but worth it and hard chromed to

I don't know if I'm right but it was my understanding that most 38 SC guns are built with a .355 (9mm) barrel instead of a .356 (38) barrel and that acually makes most 38SC guns 9x23 am I right.

Thanks with a regular tool head they very .003-.004 sometimes more and that is one out of ten most are pretty consistent with in .002 but I'm tired of checking all of them

Has no one ever used one .I'm thinking of trying one to keep my OAL the same anyone know if they work or it is a waist of money, Joe

Try www.microfasteners.com I probobly have some but I'm out of town till Wednsday if you have no luck let me know and I will look what I have when I get home,Joe

Which Aimpoint are you guys refering to Micro, Comp-C or M-4 which one.Just wondering

wondering if anyone has tried a Unique Tek floating die tool head on a 550.And how well it works