Jump to content
Brian Enos's Forums... Maku mozo!

Studlee

Classified
  • Content count

    70
  • Joined

  • Last visited

About Studlee

  • Rank
    Finally read the FAQs

Profile Information

  • Gender
    Male
  • Location
    Tampa, FL
  • Real Name
    Lee Nuguit
  1. Grip Tape

    Use an old toothbrush and alcohol to clean surface and let dry. Then use heat gun to warm up the grip and tape. The heat on tape will make it more pliable for the curved surfaces. Sometimes the edges don't stick well, I'll use Slow Jet glue in those spots. It still allow tape to come off without ruining grip later.
  2. Wet tumbling brass - primers in or out?

    After wet tumbling and rinsing of the brass, I blow them them with air compressor to blow most of the water away. Then lay them on a towel for a day before loading.
  3. From Naples your not too far from some east coast matches outside of Miami and north. Check out http://gunmatchadvisor.com/filter for FL.
  4. I use One-Shot Sonic Cleaning Solution for cartridge cases. A few drops is all that is needed. Wet tumble for 1.5 hrs and inside and out is super clean. Using Dawn would take 2 - 2.5 hrs. After separating brass from the pins and rinsing the brass, I use an air compressor to blow off the extra water, then lay out on a bath towel. All dry in a couple hrs.
  5. 5.25 Dawson Front Sight Height Question

    I emailed Dawson and they recommended the .225x.100 for the front sight. It's been perfect with no adjustment to rear. Hit POA. For sight tool I went with Fisher Solutions XL tool: http://www.sightpusher.com/New--XL-Tool.html
  6. SP XDM 140mm basepad giveaway

    I want two!
  7. Paper targets for practice

    For paper, I bought a bunch of these: http://letargets.com/estylez_item.aspx?item=IPSC-P
  8. M&P back straps

    Last ones I bought were from Make Ready Pro shop cuz they had them in stock. These are stippled. http://www.makereadyproshop.com/accurate-iron-stippled-m-p-backstrap-full-size-9-40/
  9. Xd 40 refinishing

    Ionbond from Springer Precision.
  10. Which Coated Bullet?

    Mostly Bayou. Have tried BBI and BlueBullets. When loading BlueBullets, you do get a blue residue on your fingers. They all shoot great though.
  11. anyone shoot 135gr bullets?

    Love the 135gr Bayou's. Good compromise between the 124 and 147. I load 3.3 of TG at 1.137 OAL for XDm 5.25. Gets me 132PF.
  12. USPSA Holster Rig for XDM 5.25

    IMO, the best bang for the buck is the Comp-Tac International. Kydex holster that comes with 3 belt mounts - Belt, Paddle, and DOH. For mags, I like the Ghost 360. Allows you to use it for different magazines.
  13. Hi cap mags for Sti

    ^^ This. 3 of my mags I'm actually able to get 21 in.
  14. slide stop issue?

    Was having the same issue and it was my grip but was caused by my support hand. I'm a right handed shooter with thumbs forward grip. My left hand rides high on the grip which causes the back of my left thumb to ride on the slide stop. I replaced with Springer's slide stop which fixed my issue without changing my grip.
×