WildWest N AZ Posted August 11, 2010 Share Posted August 11, 2010 Checking my Hodgdon book out for some start loads for my G17? I started with 3.2 grains to see how i like that? Has anyone gotton close to what hodgdon state's max charge is 3.6, and if so how did the load handle ect? Not looking for major or anything. Just wondering cause 4 tenths more of a charge would have me at max loading and im not one who likes to chance over presure loads.... Link to comment Share on other sites More sharing options...
vluc Posted August 11, 2010 Share Posted August 11, 2010 I've been loading 3.4-3.5 of TG under 147's for a good number of years and have seen no issues. They run about a 133 PF for me in a G17, higher in a G34. Link to comment Share on other sites More sharing options...
jkatz44 Posted August 11, 2010 Share Posted August 11, 2010 I once went up to 3.6 TG in my M&P. It worked fine but the extra recoil was not needed. 3.3 to 3.4 makes about 130 pf. That is where I like to be. Link to comment Share on other sites More sharing options...
xcelr8hard Posted August 11, 2010 Share Posted August 11, 2010 3.5 under a Bear Creek at 1.14 oal. Shot from STI Trojan 146PF, no signs of over pressure. Accuracy was horrible, 2" at 15yds. Butch Link to comment Share on other sites More sharing options...
Aircooled6racer Posted August 11, 2010 Share Posted August 11, 2010 Hello: 3.1 grains of Tite Group with a 147 Precision moly bullet make 131PF in a Glock 17 and 136 in a G34. 2.9 grains is right at 125PF in the G17 loaded to 1.140" Thanks, Eric Link to comment Share on other sites More sharing options...
BayouSlide Posted August 11, 2010 Share Posted August 11, 2010 I've found that 3.3 grains of Titegroup with 147 gr Zero JHP will make around 136 in a G34, about 2-3 less in G17 IIRC. Curtis Link to comment Share on other sites More sharing options...
WildWest N AZ Posted August 11, 2010 Author Share Posted August 11, 2010 Thanks everyone! Just was wondering how it preformed on the higher side of loading? I just starting playen around with my 9 loads. Ive had pretty good results with 3.2 TG 1.120 oal +/- a tenth of grain with Berry's 147's so far, accuracy seems good out of my G17. I know Hodgdon's stated max load is not on line of blowing things up, but they have put that data like that for safety reasons ect Im guessing? Link to comment Share on other sites More sharing options...
TonyT Posted August 11, 2010 Share Posted August 11, 2010 I use 3.4 gr. Titegroup behind a 147 gr. FMJ for slightly over 900 fps - very consistent but Titegroup is a hot burning powder. Link to comment Share on other sites More sharing options...
WildWest N AZ Posted August 12, 2010 Author Share Posted August 12, 2010 I use 3.4 gr. Titegroup behind a 147 gr. FMJ for slightly over 900 fps - very consistent but Titegroup is a hot burning powder. Thats foresure... can always tell what brass is mine after a stage cause its nice N warm still! LoL Link to comment Share on other sites More sharing options...
SA Friday Posted August 12, 2010 Share Posted August 12, 2010 Keep in mind you are stating reloading data without OALs. I would imagine the book specs is for a shorter OAL than you are loading and that will affect the chamber pressures reached. Also, TG throws extremely accurately. It isn't a fluffly flake powder and doesn't waiver at all after the powder throw is set. It meters extremely well and consistant. So the chances of the throw waivering too close to an overcharge is pretty low with TG in comparison to some other powders. I regularly say that TG is probably the best powder for pistol shooting on the market for jacketed bullets. It's really hard to go wrong with it short of the regular open division calibers. Link to comment Share on other sites More sharing options...
WildWest N AZ Posted August 12, 2010 Author Share Posted August 12, 2010 Keep in mind you are stating reloading data without OALs. I would imagine the book specs is for a shorter OAL than you are loading and that will affect the chamber pressures reached. Also, TG throws extremely accurately. It isn't a fluffly flake powder and doesn't waiver at all after the powder throw is set. It meters extremely well and consistant. So the chances of the throw waivering too close to an overcharge is pretty low with TG in comparison to some other powders. I regularly say that TG is probably the best powder for pistol shooting on the market for jacketed bullets. It's really hard to go wrong with it short of the regular open division calibers. I did forget to add that in Hodgdon has its max load with 147's with OAL @ 1.100 Link to comment Share on other sites More sharing options...
PBA2 Posted August 13, 2010 Share Posted August 13, 2010 3.5 TG under 147 PD truncated 1.150. no problems and accurate Link to comment Share on other sites More sharing options...
WildWest N AZ Posted August 19, 2010 Author Share Posted August 19, 2010 Update: so after 300 rounds of 3.2 tg, 147's berrys, and 1.120 oal run through my 17 I feel that its plenty accurate, no jams, and feels great to shoot. The only issue that I did run into was with that powder charge not haven enough steam to knock down beat up ol'steel poppers @ 35 yds. So I think that I will give 3.4-3.5 grains of TG a try to see if that eliminates that problem? Link to comment Share on other sites More sharing options...
vluc Posted August 19, 2010 Share Posted August 19, 2010 Update: so after 300 rounds of 3.2 tg, 147's berrys, and 1.120 oal run through my 17 I feel that its plenty accurate, no jams, and feels great to shoot. The only issue that I did run into was with that powder charge not haven enough steam to knock down beat up ol'steel poppers @ 35 yds. So I think that I will give 3.4-3.5 grains of TG a try to see if that eliminates that problem? Run them through a chrono, best way to tell anything, and unless you know what those poppers were set at, failure to knock them down may not be reflective of anything. Your load is probably giving you a lower PF than you think. 3.5 TG, 147's at 1.158 in a 17 give me a 133 or so PF. Your PF may be much lower than that. Link to comment Share on other sites More sharing options...
WildWest N AZ Posted August 20, 2010 Author Share Posted August 20, 2010 Update: so after 300 rounds of 3.2 tg, 147's berrys, and 1.120 oal run through my 17 I feel that its plenty accurate, no jams, and feels great to shoot. The only issue that I did run into was with that powder charge not haven enough steam to knock down beat up ol'steel poppers @ 35 yds. So I think that I will give 3.4-3.5 grains of TG a try to see if that eliminates that problem? Run them through a chrono, best way to tell anything, and unless you know what those poppers were set at, failure to knock them down may not be reflective of anything. Your load is probably giving you a lower PF than you think. 3.5 TG, 147's at 1.158 in a 17 give me a 133 or so PF. Your PF may be much lower than that. I will give the chrono a run to see what PF is? Seems from what ive read around in old posts is that the load Im playing with currently is a good one to start with? Although so many variables being different from climate ect ect that load maybe better there than here or other way around for someone else? Also I had no other problems knocking down any other poppers that evening, so maybe that one was not calibrated correctly? More testing for sure... Link to comment Share on other sites More sharing options...
vluc Posted August 20, 2010 Share Posted August 20, 2010 The chrono is your friend. You really can't effectively reload without one. Link to comment Share on other sites More sharing options...
WildWest N AZ Posted August 21, 2010 Author Share Posted August 21, 2010 The chrono is your friend. You really can't effectively reload without one. Thanks for all the help! WWNAZ Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now