parashooter38

does anyone know if a carver cmore mount on a glock 34 will fit in a ghost holster? Thanks

I used a longer ejector and put a 30 degree back cut on it. It makes the case come out downward instead of up into the scope If you have a fax number ill send you a little drawing of what I did

i think it is because of the pressure you would put on the machine do to the necked down case

dillon does not make a set up for 357 sig on a SDB

What kind of gun are you going to use it on?

Have you pulled the extractor and cleaned the the hole out. Some time you get a lot of gunk in there and it effects the way it works

how do i put a picture on here if if can ill put the diagram on and anyone who wants to can use it

p.s. i still have the diagrahm of the ejector if anyone wants it I would have to send it to you on an email because i dont know how to pics on here

I ran one on a para frame with a sti slide. put a 30 degree back cut on it and it ejected all the cases down and not into your scope. I also always used a slide racker so i never put my hand near the port

tactal supply depot has them for around $20.00 dollars

I have had jam problems after reloads. and found out that most times it was me. I tend to loosen my grip during the reoad and then not grip it tight enought and get a stove pipe. But im working on it and getrting better at it

I had a problem where my rounds were to short causing the top one top overlap and push nose into the front ofthe mag

Is there a rule in uspsa that does not allow an optic to extend past the rear of the slide?

I have one on a glock 34 with a few thousand rounds through it with no problems. i red loctite the mount to the frame and the same with the dot to the mount its solid

Looking at the first picture the c-more is extended way past the end of the slide. I thought there was a rule against that in IPSC.

I have one on a Glock34 with a few thousand rounds through it and it works great no problems

Titusville rifle and pistol club is running a steel challenge match on the second sunday of the month 5 stages I shot it today

rcbs 10/10 scale is great think it will stand up much better than an electric scale be sure you get the green one because the tan one is metric

I run 7 1/2 three dram ounce and an 1/8 with a remington1187 12 shot tube with a ful choke

after i make the bullets i run them in the tumbler for about 15 minutes. it cleans off all the lube

I shot a glock match on feb, 1st at the central florida rifle and pistol club. Glock posted the order of finish in a few days but have not yet posted the prizes, Anyone know why it takes so long?

I shot a glock match in central florida on the first of the month and by the 4th of the month the results were out. This is a first for glock it usually takes a few weeks to post them.The prizes will probably take a few weeks but their getting better

I use my barrel as my case gauge if it fits in the barrel it should be good to go. Factory case gauges seem to be a little more tight and reject more rounds. Used my barrel for my 38 super and now that im back shooting a glock 34 i do the same thing. almost never have a problem

major or minor is for power factor in uspsa shooting. minor is 125 power factor and major is 165. they multiply your bullet weight by how fast it goes through the chrno

I have two of them. the newer model is a little more quiet. The both work quite well.