I'll apologize upfront if I seem dense on this.
But I'm still trying to figure out exactly which surfaces of the T3 disco need work.
I see Adam's photo (attached here again) showing the surface to remove material from.
But then I also see posts from others talking about working on wings, faces and legs.
I'm sure this will make more sense once I tear the gun down and start reassembly with new parts.
But I'm trying to get a clearer understanding about which areas of the T3 disco will need modification to install in a Stock III with a once-piece sear.
What I think I know:
1. The pin hole needs to be enlarged
2. The leg surface, as shown in this photo, needs work.
If there's anything else, it would be so helpful (and I realize I'm asking a lot) to see a photo with arrows pointing to the area that needs work.