rlapid216

I have 3 10rd mags that are factory dimpled in the 17rd tube that fit the x-carry grip (essentially the x-five grip with a shorter rail and no magwell). I bought a NY state X-Carry off gunbroker and I don’t need them.

Thanks for clarifying that with hard evidence.

this uses Ryobi one+ batteries and is already set up as a mister https://www.homedepot.com/p/Arctic-Cove-18-Volt-2-Speed-Misting-Bucket-Top-Fan-MBF0181/205744083

Nice! I saw those awhile back on some FB page, but I don't remember seeing info on it. I like the design. Might have to try it out.

It looks great! PM sent Sent from my iPhone using Tapatalk

Hey Eric, please have your son look into it. However, I'm more than happy if we just double stick tape the thumb rest. I'm not looking into modifying the grip permanently.

yes, for 3 gun. I have a RHT level 2 holster that I feel confident while running around

thanks for checking! Sent from my iPhone using Tapatalk

would you know if the TXG grip weight weighs more than the regular X-Five grip weight at 1.6 oz?

I was hoping to continue using my RHT holster without butchering it up too much. I'll look into aluminum angle and grind it down to small nub

I was thinking about that, but I didn't want it to be permanent. I can probably put some kind of release agent on the frame. I'll see how inspired I'll be, thanks!

They offer a .20 cal pin. I assume the shaft is thinner to clear the shoulder. It's one piece and more expensive, though. https://www.mightyarmory.com/collections/made-in-the-usa/products/decapping-pin-for-22-250-and-243-special-order-only

Hey all, As I patiently wait for GoGun to make a left hand version for their P320 thumb rest, I'm hoping someone can 3d print a left hand version now. I'm not looking for the take down shaft, just the thumb nub to double stick tape/glue to the right side of the frame. Of course this means I'm looking for someone who: a) has the thumb rest, b) has a 3d printer, c) can mirror the right hand version. Obviously, monetary compensation is involved. Any help is greatly appreciated! FYI, GoGuns stated the left hand version is on the drawing board, but will be released after their Glock version.

Got the plate from Rick. [emoji106] Sent from my iPhone using Tapatalk

my local monthly gun show had several vendors selling VR80's for $599. I was able to pick up 2 19rd mags for $55/each out the door. Glad I went! No other parts were available, though