SD1

Anyone using a cement mixer with pins?

It will be some work. But with clean bore snake and plastic wax you can get it back right. Or just get a new one 12$ plus shipping

Its worth it...drop the dime

How is the reliability of the Tula primers?

Call or email him.....be honest. He will probably warranty it. He stands behind his products.

Anyone getting powder checks or powder level sensors?

Case feed tubes I use cotton balls with Iso Alcohol, Powder tumbler tube #1 don't leave powder in, Same rub with Alcohol.

+1 GREAT CUSTOMER SERVICE

Put tester on continuity. Touch center post of PLUG and touch ground and hots on battery plug. That will tell you what it is

He is a good dude and honors his products. Buy with confidence from Inlinefabrication.com

Do you have a electrical tester?

Its a 4$ bearing.....low value. Don't matter if he is wrong or rite. He is the customer with a complaint. So you take the high road as a buisness and send him a bearing. The customer is always right.... The 4$ bearing will cause him and 10 of his friends not To purchase Dillon Equipment. YOUNGEYES you are a asset to the forum. A+ brother

make sure bell crank cube is going stop to stop. VARGET powder???

Petco, pet smart large stores etc. Get the large bags of ground walnut or Grainger carries also

+1. Straighten spring best you can for now.

Dillon trimmers has to use a caliber specific die. Hand trimmers no..

If you order though BE you are fine. He charges and orders immediately. If ordering Dillon direct: Dillon charges just prior ti shipment..if you get charged from Dillon and don't get a shipment in over a 7-10 days then worry.

Who did you order from?

If you check some of the BIG mail order companies. they post available inventory at night, then send out NOTIFACTIONS IN THE MORNING. I have scored 223, 9mm and WSR and WSP recently

do they still have a primer detonation issues?

i would send a MO like Jackie stated.....sounds like they ship quicker

i loaded so many 40/10mm i wore out A&B collets on Hornady Bullet feeder die... does that count

i think i saw new 223 and 40 dies in a gun shop earlier this week. i will try and go back this week end and verify

it usually took a month before the craziness. but i always sent in a check. not sure if that was the delay???

if you want one. order through B.E. Store, he places the order same day. and you will save some $$$ on shipping. Nothing like new reloading equipment