sweetback

SJC 5 port comp aluminum shoots as FLAT as most and flatter than some. On my 22/45 with TANDEMKROSS VICTORY TRIGGER, Cmore 8moa dot, RimEdge scope mount, and 1.5 lb. Trigger pull. LCI replaced with TK filler, VQ sear and hammer, VQ disconnecter, TK hammer bushing, Titanium striker TK, Eagle talon extractor. With CCI Mini Mags it runs FLAWLESS. Sent from my XT1080 using Tapatalk

No,but I just ordered the IDP Flat Line Trigger V2 to try out.

I have to disagree. Saw both movies Scaramoche/Princess Bride. Princess Bride better fight scene of the two.BUT not by much.Both were excellent.

Yes 9mm - I'm starting longer 1.070 Wasn't sure if that was to deep. 100gr Berry's HBFP were loaded at 1.050 Let me know how they feed. I Will be trying a few rds. out tomorrow.

What O.A.L. do you load to for shooting steel challenge, Using Bayou 105gr. FP? Sent from my XT1080 using Tapatalk

My remedy for weak mag springs is as follows: Two sets of magazines. One is for practice only,the other for MATCHES only. You'll find that your match only mags will last a lot longer. And if you replace the springs in the MATCH only mags yearly you will will not suffer from failed mag springs.

Sent from my XT1080 using Tapatalk

JP Mag well for GLOCK 17 can be massaged to fit a G19. Sides machined down to fit in the IDPA box. Insert is aluminum and legal. Sent from my XT1080 using Tapatalk

Sent from my XT1080 using Tapatalk

I used a Dremel sanding drum. Sent from my XT1080 using Tapatalk

Ghost I had to relieve holster to accommodate weight. SJC offers this service if you send them the holster. Sent from my XT1080 using Tapatalk

The HEAVY HITTER 2.0 It weighs 44 oz. without the 20rd. Mag and Taylor freelance brass extension. Would never shoot LIMITED without it. Sent from my XT1080 using Tapatalk

GLOCK 41 Limited 10/CDP with magwell. Sent from my XT1080 using Tapatalk

Mine passes the vertical test with 4lb. Wolff striker spring and 14lb recoil spring.

Sent from my XT1080 using Tapatalk

No I had our club machinist/gunsmith machine it to spec. 1.368" thick. IDPA BOX with spacer is 1.375"

It's a G19 gen 3 sights are Ameriglo tritium front and rear.14lb wolf recoil spring and steel captured guide rod.

CARVER Big Mouth magwell thinned down to fit in the 1 3/8" width IDPA box. Stock mags will seat flush in magwell. Sent from my XT1080 using Tapatalk

What he said.

I have had the best results with Federal primers.With a 4lb. Wolf striker spring and flush seated primers the work every time.I also use an extended tip skeleton striker.

It's OK!

Yes. G21/G41 gen 4 aluminum Big Mouth mag wells are the same.

The Big Mouth will fit G21 gen 1-2-3.When ordering for (G41 gen 4) indicate G41 gen 4.

It fitsSent from my XT1080 using Tapatalk

Glock 41 CDP fits in the IDPA box with CARVER Big Mouth cut down and magazine flush.Sent from my XT1080 using Tapatalk Sent from my XT1080 using Tapatalk