dnmccoy

I dont mark either, but my friend puts an "X" on the bottom with a sharpie

+1 on walnut and nu-finish. 90 minutes and brass looks great!

I wonder if someone painted it or put some kind of coating on it?

Welcome back!

I sort first then tumble. Im going to stick with walnut in my Frankfort Arsenal tumbler. Its faster and I get more done at a time. I then run them through the Dillon media seperator a couple times and Im ready to load!

All reasons I dumped my electronic for a beam type. A little slower, but much more accurate and reliable

Mine is silver as well but looks the same

Ive used Xtreme plated bullets from TJ Coneveras Tj Conevera with great results Heres my last batch

online only or in store?

I do it all the time, just be slow and gentle and all should be well

Ive had mine for about 6 years and even though shes been run through her paces, she still runs like a champ!

Thanks Kevin Im going to go ahead and order a couple to test out, not quite sure I need the 50$ Uniquetek

I had the same problem on my G19 and had a heck of a time trying to figure out what it was!

Thats a darn good group for a m1...Id take it

Ive seen several versions of knobs that go on or replace the bolt on the powder measure for the 550s and was wondering if they were any benefit other than easier to turn than the bolt?

I got my 550 for 9mm but also for my 30 carb and eventually 30-06

My good friend has had good results with surplus powders through his .50BMG, I think he got it from Wideners

I too have been investigating replacement sights for my g19 but am not sure which would serve me better yet

Thats definitely an interesting concept!

Welcome aboard!

Welcome!

I also use W231 under my XTREME 124gr PRN with an OAL of 1.15 in my G19

I have not noticed any difference in my small pistol ones. Ive used about 3k in the last month or so and they seem the same

Hello all. My 550 came via brown santa today and I could be happier! I got it from a guy who bought it, loaded with it for a week and didnt like it. First off, I got the manual that came with it and I dont see any info on mounting the press into the strong mount. Im assuming its pretty straight forward by just bolting it in? After mounting it like that, I mounted the finished case bin on the said, and the roller handle is hitting the bracket that it mounts too. Any ideas? Can get pics up in about an hour or so if needed

Looks like a great little setup.