chuck s

For NFC, sure, USPSA rigs are fine

not if you use the SP01 mags. an extended base pad does give you better mechanical advantage when inserting, but the m&P pads work

It seems like I remember a change in reloading and engagement of targets in halls and rooms. Maybe I just got confused in all the shuffling of rules lately.

Does anyone know where I can find the latest changes to the 2015 rule book ? I know there was an addendum that came after some confusion on the newest rule book.

That looks like he has the EG trigger on there. It changes the dynamics a good bit.

Most guys around here that use xtreme bullets use their .357 147gr bullets. I find them more accurate in my CZ and tanfo

Too short to use with a CZ magwell.

Also found out that S&W m&p base plates also fit perfectly on CZ mags (9mm) and work with the mag well if trimmed a bit. The compact m&p plates work with no trimming.

Unless you need to load longer rifle rounds, I would rebuild to RL specs. I have both and the RL is a much smoother machine.

What does work with a mag well?

That one has not been rounded yet

File the sharp edge of the slide stop down a bit

All you have to do is file of the engaging edge of the slide stop a little bit at a time to tune to your liking. My stock 3 wouldn't auto close , but after about 3 minutes with a small file it does so every time.

my lim pro, stock 2 and stock 3 all have the same size mag well. stock 2s are still not legal for idpa, secondary to the length of the bull barrel. the stock 3 simply weighs too much, although perhaps it could be lightened enough to make weight if taken from the inside of the frame or slide.

i would at least try polishing the firing pin and the FP bore, as well as checking the FP block for burs. At least on Tanfos, this really helps

That is a long slide sitting on the gun, not a match upper.

My match frame has no rail and thus is lighter than the rail guns, everything from my LP fits the match frame except grips.

Sorry, I didn't know that . Get a Henning SA trigger set up then.

Did he say it was SAO?

eg one piece sear, eg hammer,eg light plunger spring,light sear spring, extended firing pin with eg fp spring,egw lighter trigger return spring, polish everthing. trigger will be light years better than factory. forgot. eg light hammer spring

That's what I plan to do, if it works ok I will go with it. The SA pull is very good, crisp and very light. This is an easy project and any one here could do it.

the limited pro is the best all around gun eaa sells. idpa,uspsa legal and feels virtually identical to the stock 2. very hard to come by in 9mm, but a .40 shoots very nice also, in minor loading.

Can you use the one wing disco with a one piece sear?

Makes sense. Assuming that the gun runs well otherwise, do you think it matters? Full cock seems fine.

Nealo, why do you think it works ok with the fpb out?