Patrick1981

the mainspring on your 625 is the standard type or the reduced power with the depression in center ?

Awesome job, congratulations !

How I can replace the fiber optic rod on a SDM super sight ?

Che bei premi !

"I have seen forum post that suggest using a 38 resizing die with 9 mm expanding,bullet seating, and crimping dies". I see something like that, but actually I never tried to use 38 short, but I'm interested know if the 38/357 dies is good for expanding and crimping on a 38 LONG colt brass.

Anzi, meglio di no come primo, altrimenti non li vinco

Propongo come primo premio un pò di inneschi Federal Non sarebbe male eh ?

I istalled the SDM open latch (Idpa legal) On the box i read " little or no fitting required ". I think when she said little fitting, he talk about the height.. I attached two pics, fot you is better hold like that or lower removing material ? The screw now does not work so screwed up at the bottom, but almost half Thanks

look some Nill Griffe grips, after 6 year I buy it for my 686 and I love it comfortable shooting sessions, speedloader friendly and very good recoil absorber

Anyway, install an extended firing pin

Can a SDM supersight fiber optic 0.300" work with a LPA rear sight ? I think the 0.250 version is too low for this rear sight Thanks

Mhh, i think I want to love overtravel, it's the cheapest and fast way And maybe the best for DA shooting Thanks

have a pics ?

Your SDM fiber optic sight is a 0.250" high ? Thanks

Thanks, I'm going to try it

Yes it is IDPA Legal ok, but you see the difference in opening the cilynder or is very little ?

Who have an experience with the improved SDM open latch (Idpa legal) ?

Ty Hambby, is this thumb latch made by california competition works different design by the one in your photo ? http://www.dillonprecision.com/#/content/p/9/pid/25151/catid/17/California_Competition_Work__039_s_S_amp_W_Revolver_Thumb_Latch_S_amp_W_Thumb_Latch__Silver

Thanks for advice

Yes, I think it's a job that affects many users of aggressive speedloader, with Safariland speedcomp III or Jetloader But if you reload with switch hand, keeping firmly the cilynder in the weak hand it is unlikely that could happen

I don't know if it's possible, it was the first time i made this job My opinion laser is more accuracy Work with a steel hair of 0,2 mm. (0,008 inch)

how much longer should be about a pin rod set for DA comparing the SA ? I know the finally setting is different for every gun

Cas, you talk about some kind of epoxy resin ? Sticks firmly to the metal ? Thanks

You talk about a pin rod ?

I finally solved the problem and it works great