Rolex

As some have stated above go with a set of Dawson sights, adj. rear FO front-ya can't miss.

I installed a LW in .40S&W for a Glock 35 very nice fit-drop in no smithing at all. has very good support, and shoot's very well - BUT only used FMJ 180GR MG. Put over 2k rounds in it so far no problem, and reloading the brass is very easy-go for it. SP check

MG 180FMJ 4.5gr. VV N320

Put the one I had away-purchased new sights from Dawson and the wrench fit just right-no problem

Did it- just as informed works great!

Thanks for the feedback-just a very odd hole and pin- that falls out and appears to do nothing!

Anyone have a new style ghost holster. I purchased one today and am wondering what the small black pin is there for = located on the top section of the rod that the outside of the holster rides up and down on. It just falls out and is connected to nothing that I can see.

My front sight brok off on sv limited gun. Purchased new one from sv. Need some help on the new install RE: file down the sight dovetail with file or emery paper?

Call Vanek and you won't have to think about let off! Try a Glock with this setup and then you'll understand my statement!

Check with speedshooter.com I think they just some new ones in.

I use a Lonewolf- drop in with a more supportive chamber, very good with MG 180FMJ and VV N320 at 1.135OAL>

Thanks for all of your help- I will try a spacer and thanks for the battery info!

Have a 170mm tube with Grams spring setup as well as a Bolen. Holdes 28 .9mm BUT after every three rounds the next one nose dives into the front of the mag tube. OAL is 1.160 for my 9mm. I dont know if its a STI or SPS. Do I need to put a spacer in the mag? Will this take up the loose fit. Also unable to find batterys for the CMORE Duracell DL 1/3N or Energizer 2L76 Lithium- no cross reff. for these in several stores!

Thanks all- will order one ASAP

Go with the Dawson Ice Mag Well

OK OK but where is north mountain?

Hard to get at times-Powder Valley- +1 for these loads , I use n320 and 3n37.

C that's what I call a blaster. Very nice and enjoy!

Try Get'nGrip jim@getngrip.com or DVCJim on this forum

Jim did the grip on my Glock35 it's like shooting a new type of Glock

Google Ford's guns in Florida. They did one of my revolvers and I think they do all of Dawson's pistols. I think it is fordsguns.com They did a fine job on my revo and its SUPER bright. Thanks for the help- I'll call them tomorrow

Is there any place in the Florida area-or outside-that you have used to chrome a hand gun. I have a SV frame that I want to have chromed to match the top end.

R U using Glock brass?

VV N320 is the way to go- 4.5gr MG 180grfmj