Bobber Target

[beechnutbob]

Made up this Bobber target.   Can give material list and dimensions of anyone is interested.    Requires addition wood or metal stand to hold piece of plate steel to block off part of the target.  If you have some weights laying around cost of the steel around 30 dollars

[Patrickxx]

That looks interesting. Have you shot it yet? How do you like it? 

[beechnutbob]

They have these at club in Florida. It depends how high u set the steel in front of the target to increase or decrease the amount of the target that shows when bobing and how much of the head shows when at rest.  Then add distance and it can be a easy or difficult depending on skill level of the shooter.  The steel will ring so you know if you miss low and can make up shots

[MemphisMechanic]

Great design. I was already planning to build something similar. Thanks!

[beechnutbob]

1 1/2 inch light angle

2@22”

2@18”

2@25”

2@6”

 

3/8 x 1 flat stock

5@18”

 

1 x 2 inch tubing

2@6”

 

1 inch OD pipe

2@18”.      Can weld nut inside pipe and use bolt for pivot point thru upright

 

3/8 inch nuts and bolts and a weight around 20-25 pounds

should be able to figure out from picture where to drill holes and if any questions can email or post here

 

[22 shooter]

Any one selling these?

[Sarge]

1 minute ago, 22 shooter said:

Any one selling these?

Range master steel

 

https://rangemastersteel.com/bobber-target.html

Edited May 6, 2020 by Sarge

[davidb72]

Our club has two of the Range Master steel bobbing targets and they are real nice.

I should probably try and use them in stages more than I do.

We have their Max Traps as well - also very nice.

[Kokeman]

Thanks. I building one this week.

[Kokeman]

Thanks for inspiration. Can't wait to try it out at the next match.

  

[Kokeman]