Sniperboy Posted April 1, 2017 Share Posted April 1, 2017 Just to be sure, is this the "Canik pin" everyone is talking about to replace the trigger pin for the Stock 2? https://cajungunworks.com/product/30600-floating-trigger-pin/ Thanks for your patience : ) Link to comment Share on other sites More sharing options...
johnbu Posted April 1, 2017 Share Posted April 1, 2017 Yes. Link to comment Share on other sites More sharing options...
MemphisMechanic Posted April 1, 2017 Share Posted April 1, 2017 I'll have a video up by noon tomorrow that shows how much wiggle it creates in the trigger, by the way. Link to comment Share on other sites More sharing options...
blsexton Posted April 1, 2017 Share Posted April 1, 2017 Will this be the way to go for a Stock 3 as well? Link to comment Share on other sites More sharing options...
johnbu Posted April 1, 2017 Share Posted April 1, 2017 ^^ yes. Link to comment Share on other sites More sharing options...
Sniperboy Posted April 1, 2017 Author Share Posted April 1, 2017 Thanks John. Looking forward to the video MM as usual. Link to comment Share on other sites More sharing options...
C-Money Posted April 1, 2017 Share Posted April 1, 2017 The pin is legit and works. Link to comment Share on other sites More sharing options...
zombywoof Posted April 1, 2017 Share Posted April 1, 2017 I don't notice any problems. Link to comment Share on other sites More sharing options...
MemphisMechanic Posted April 1, 2017 Share Posted April 1, 2017 8 hours ago, Sniperboy said: Thanks John. Looking forward to the video MM as usual. The videos are up. This will definitely sell a Stock II/III user on it after watching me pop mine in, and having to hammer the roll pin into theirs with a prolific amount of swearing as they follow along. Link to comment Share on other sites More sharing options...
mjmagee67 Posted April 2, 2017 Share Posted April 2, 2017 I have two S2's and got two pins for the trigger. One fit fine the other would not go in. Link to comment Share on other sites More sharing options...
himurax13 Posted April 3, 2017 Share Posted April 3, 2017 22 hours ago, mjmagee67 said: I have two S2's and got two pins for the trigger. One fit fine the other would not go in. Some Tanfo frames vary in tolerances. Link to comment Share on other sites More sharing options...
EngineerEli Posted April 3, 2017 Share Posted April 3, 2017 I use the canik pin in my stock II, and Just ordered one for my new Lim Pro. If I recall, if your trigger pin holes are a little small, just chuck the pin up in a drill and hit it with some fine sand paper, checking frequently until the pin snugly fits. I think I used 320 for fitment then went 600 and 1500 to polish, and finished up with a paper towel with some mothers polish for a mirror finish. Link to comment Share on other sites More sharing options...
zombywoof Posted April 3, 2017 Share Posted April 3, 2017 I had to drive mine in like the roll pin Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now