What insert for CR speed pouches with Stock 2 Mags?

[Shadyscott999]

I can't seem to get any to work. Suggestions?

[kneelingatlas]

Large frame? What's the problem? I use three: thin plastic, thin rubber and one of the think ones.

[Shadyscott999]

Large frame? What's the problem? I use three: thin plastic, thin rubber and one of the think ones.

Yeah large frame. i may be missing parts. You don't happen to have a pic do you?

[BiggMike]

You are going to have go to Lowes and get some flat thin rubber washers. That was the only way I was able to get my mags to fit securely. Get the medium size rubber washers. It will be a little trial and error but it works. I think you will need either the 1.5-2 inch x .25 thickness.

[Shadyscott999]

You are going to have go to Lowes and get some flat thin rubber washers. That was the only way I was able to get my mags to fit securely. Get the medium size rubber washers. It will be a little trial and error but it works. I think you will need either the 1.5-2 inch x .25 thickness.

Thanks. I ended up making my own spacers using SS washers I had in the shop.

[Prov1x]

i used the little long shim looking things. put the thick part on the bottom of the mag holders and the spacer over it and they work fine.

[kneelingatlas]

Large frame? What's the problem? I use three: thin plastic, thin rubber and one of the think ones.

Yeah large frame. i may be missing parts. You don't happen to have a pic do you?

I have them setup for small frame mags at the moment.

[Attila]

I use the CZ shims that came with the pouches. I cut the "L" on the end off.

[mwc]

i used the little long shim looking things. put the thick part on the bottom of the mag holders and the spacer over it and they work fine.

This worked perfectly!

[EngineerEli]

I use the CZ shims that came with the pouches. I cut the "L" on the end off.

Exactly what i did with my stock II large frame worked perfect! (I think it was the CZ ones, unless it was the Glock ones, I would check before cutting.)