adjustable trigger stop

[ChopperDoc]

I've been looking at the LW adjustable trigger stop and am wondering if it's nothing more than a factory part that is threaded for a set screw. any reason I can't do this myself? What am I missing? Anyone know what size screw is used?

Thanks

Edited September 6, 2010 by ChopperDoc

[BayouSlide]

Factory part threaded for small set screw. For best results, smooth and round the tip of the screw that will contact the trigger bar.

Curtis

[Aircooled6racer]

Hello: The setscrew is a 4-40. Thanks, Eric

[ChopperDoc]

Hello: The setscrew is a 4-40. Thanks, Eric

thanks!!!

[Braxton1]

Hello: The setscrew is a 4-40. Thanks, Eric

thanks!!!

Only caution is that this part is plastic. If you don't drill it out big enough, it will just stretch around a tap and swell out. This will cause issues when you put the actual setscrew in and make it difficult to get the trigger housing back in....

[ChopperDoc]

Hello: The setscrew is a 4-40. Thanks, Eric

thanks!!!

Only caution is that this part is plastic. If you don't drill it out big enough, it will just stretch around a tap and swell out. This will cause issues when you put the actual setscrew in and make it difficult to get the trigger housing back in....

do you happen to know the correct drill size for a 4-40 tap?

[Jman]

do you happen to know the correct drill size for a 4-40 tap?

http://www.boltdepot.com/fastener-information/us-tap-drill-size.aspx

[Jaxshooter]

We never use to use a tap for the set screw hole. The set screw it self will thread the plastic. Jut take your time screwing it in.

[JBP55]

We never use to use a tap for the set screw hole. The set screw it self will thread the plastic. Jut take your time screwing it in.

Exactly what size drill bit and set screw do you use?