TKJ

what the load you are using in yours? 9.8grains of Vihtavuori N105, 124grain RNFMJ bullet, COL 29.00mm PF 168- 170

Works the comp really nicely and i reload my rounds so the cost is about the same as .40 Im getting 26 in my IPSC legal bigstick which is more than enough, if stage requires more there will be places to reload on the move.

Im running Open Glock 22 in 357SIG aswell and i find 12lb wolff spring to be the best choice for me. I have also tried 15lb ISMI but it makes the gun dip when the slide returns to battery.

Pretty easy to do, takes only few minutes with a proper cutter in dremel.

www.dormertools.com/

The magwell on the open gun (right one) is so functional that if the mag goes even near it, it will suck it in and hey, they didnt cost me $100 each only $8

I have 2 magwells that have build straight to frame, other is from Loctite® 3022 and other from Loctite® 3024 so it doesnt have to be same material as the frame, these loctites have been workin pretty nicely

If your using stock barrel i wouldnt recommend using VV N320, thats too fast powder and makes your brass swell. Im using VV N340 with 200grs bullets and no sign of swelling.

There is a CZ 25-rounder available http://www.shop-cz.com/objects/1074636694.html

Yes it will work

Heres the setup to make them run 21+1. * Custom lenght ISMI spring * Customised Glock follower * Arredondo +5 Pad * Glock .40 Magazine This setup runs perfectly and never had any mag related malfunctions.

Keyholing issue is what usually comes with bad quality plated bullets, ive seen it on many different guns and when changed to jacketed bullets they run fine.

Never had any troubles with twentieth round, not even with ismi´s 14 coil springs.

They should do two models, with rails and without rails. I would go for the no rail model because now its easy to drill and tap the frame for scopemount.

You think $23 is expensive, here the same ammount costs $43 and the shit is even made here.

Did you chop your spring to get 21 to fit? Shortened but stiff ISMI spring and thinned follower.

I love Arredondos 140mm pads, gets me 21 rounds of 40´s.

Id use just a sharp knife to remove the glue. If you want non slip grip, i have used this one http://www.plastidip.com/consumer/index.html and it works really great.

I dont know about that but stock part works great in 40S&W/357SIG with Carver Mount. Havent had any ejection promblems with 12lb recoil spring.

Great looking guns you got there.

That would be something Arredondo 170mm Glock extension. I just love his other Glock extensions so much that im not gonna even try anything else, if his going to make 170mm extensions im definitely gonna buy and use them.

First compensator that i did was actually 4 port from stainless steel. The gun just wouldnt cycle at all with that heavy comp on top of the barrel so now its made from aluminum and it cycles flawlessly. Can you reveal some points that would help me to get it work with a stainless one, aluminum comps corrodes quite quickly so i would like to have long lasting steel one. And yes do post some pictures when you get the gun finished.

Could you post a picture?

What kind of porting it is, any pics available?

Ive got G22 with 5.3" sig barrel, lightened slide, 6 port compensator and a cmore