highhope

nice, thanks

Me too, cross dominant shooter. I shoot target focus with both eye open for easy target （~less than 15yd), and front sight focus with left eye close on hard targets and steel.

Thanks,, it's a 9mm major. Thanks, will try 7lb. Thanks, I just bought 115gr bullets and will try that too.. Thanks you Racer-x, I did set screws as you suggested, that pic is an old one. Thank you Chuck, 180 is too high, will try backing off to 170- 175 Thank you all!

thanks, I am using HS6. I am still looking for a good load...

It's a used gun, and stroked, with a 8lb recoil spring. Thank you sir. I will drop the PF to 170-175 and test a new spring..

yes sir. I am using a gogun rest

Thank you both. I will try grip harder in the range.

Man, I am almost broke after buy this one.....Open is damn expensive, for me.....BTW, thanks for helping me test fire.

Thank you sir for your advice, I will try that. My PF at FL state is about 180, I will need to lower that to a safer range 170-175.

Hello, I am new to open, shoot about two months. I have a question that the dot jumps not straight up and down but to the upper right and draw a circle. I let my friend shoot it and it jumps straight. How should I do to improve the grip to correct this issue? Thanks a lot.

Is he switching to limited?

Yes, sir. I ordered new screws, and will do. 3) That's my dog... LOL！ Thanks Yes sir. Thanks

Thank you all guys. I finally got them out, I cut the first hole of the Gogun (that's what I want too), use a pliers to turn the first screw out. Then turn the Gogun and the second one out. Now I move the Gogun two position forward, feel much better.

Thank you sir. I heat it up.Then how to run the extractor down into the hole? The extractor seems cannot go into it, is that mean the hole is too small? Thanks again.

bought a used open gun, need to move the thumb rest forward, but two screws are damgaed, pic attached I tried damaged Screw Extractor and Remove Set from Amazon, but still can not get them out. Need help, thanks a lot...

Is this match level 1 or 2? thanks a lot

Nice job! is this good for 650? thanks

Is there a IDPA CCP legal magwell for ppq 4‘?

Is there a IDPA CCP legal magwell for ppq 4‘?

Thank you all, guys... Will do that!

Ordered two titan hammers, but not come with strut and pins. Can I use factory one come with the guns. Or should I order this strut? http://benstoegerproshop.com/eaa-tanfoglio-witness-hammer-strut-4-4/ Thanks a lot

Man,that you said "walk through in dry fire" in Practical pistol show is really helpful! Thank you man! BTW, what base pad do you use for production on Q5?

I shoot stock 2 for production, sometime when I reload, my right hand index firger will engage the right safety, so just want to know is that legal to remove right side safety? Thanks ALL factory safety mechanisms, whether internal or external, must remain functional. Any other components which are externally visible may ONLY be replaced with OFM parts which are offered on the specific model of gun or another approved gun from the same manufacturer except as specifically clarified below.

I have large hands too, what grips do you use now? thx