travail

Bad primers is my best guess as well. Never had an issue with going bang with primer height variances. Just to rule out the blasters, are they stock or have they had trigger work done? Striker fired don't seem to set off all primers with low trigger weights from my experience.

I wet tumble with SS pins. To keep the cases from sticking in the powder drop die I use some Hornady One shot. I put some brass in a bucket, spray the kkne shot, and put on a lid for a bit. A few are still sticky but much easier. Prefer the wet tumbling to keep lead down when reloading.

Used the MOA lifter all season without issue on a M2. Took a small break in period but was good to go after a few hundred rounds.

Vortex UH-1 as primary with a 6 MOA Venom as offset. Depending on your primary, it may not be needed as I only used my offset for 1 target all season long this year.

Running a Vortex UH-1 and really like it. Switched from a C-More Railway. Best thing about the UH-1 is the large aiming point for close and small dot for precision. Seems to be a little faster for me on target transitions.

I also just jumped all in with a 750, from a LNL though. Been pretty happy with it thus far. Only issue was I had primers turning on their side so going in the primer pocket sideways, which you cant tell until the finished rounds come out. Dillon said they had a few parts out of spec in very early production and are sending parts to get it up and going. Best I could tell, the 750 has most of the aftermarket upgrades that you would look to add to the 650 so good deal!

I've had a lot of luck with VV N320 for heavier bullets. Running 165's with only 3gr powder. Makes power factor and sounds like a .22.

Techwell and Gibbz connected and these are now for sale with both companies.

Techwell now makes a magwell for the Gibbz pcc lower. I have one and it's awesome!

Just connected with both companies. Techwear is waiting on a response from Gibbz on a lower to design off of. Gibbz said they are trying to determine if they want to go this route or design their own but don't have a timeline. Suggest trying Gibbz to see if we can get something going as that's all my PCC is missing right now.

I also contacted Techwear and he advised Gibbz is not responding to requests about using a lower to build off of. I got off the phone with Gibbz and they said they are debating building their own, but had no timeline on when this might happen. If interested, it might be worth sending messages to Gibbz requesting they send something to Techwell to build off of as their products seems top of the line for magwells.

Best way I can describe it is almost doesn't have enough power/recoil on the bolt or something is holding it up not allowing the bolt to push the next round into the chamber. The bolt is held back behind the round as I can clearly look into the chamber to see what is going on.

Looking for some help here. New the PCC and have noticed that if I don't cycle the bolt a few times prior to the buzzer going off, the bolt doesn't seem to fully cycle on the first round or two leading to a jam where I have to drop the mag, clear, and reload. I am using the JP bolt, and their silent captured spring. If I charge the bolt a few times (when I remember) don't seem to have this issue. I have noticed it with a couple different mags (Glock factory) and have cleaned them out so don't think that is the issue. Any thoughts on the cause and how to correct?