PROBIKE101

KIND OF hard to automate that part of reloading,i run them through the checker then into the tray.not sure i wood automate that part. each bullett should be checked ,seen stage times shot too hell because of 1 upside down primer.or two or three.that will bum you out on an easy stage. your eyes and sense of touch at inspection is hard to automate,unless you have a large budget to do so..........

IDPA ALL THE WAY..........

The end justifys the means...............

want straight bullets every time?..................use a reading seating die and get a bullet feeder.

any body want to sell me the one your not using ?????????????? pm me

its fun to slice the pie............mozambiqe style.

pedometer ,switch and wire.

problem with my ponsnes 1050 is getting the primer to release off the decap pin and not jamb up the works.

if you auto drive, deprimming and sizing wood probably best be done on another processor before goin into a 1050 auto drive. that switch set up is an interesting idea.

i find my 2 stroke cranks rust up and become tuff to pull over been using stable fogging oil after i dump the gas tank an run it out of fuel spray it down the carb while fuel is running it out my 2strokes pulled over nice this season.

accurate and speed comes,try to be last to shhoot the stage,you will get a chance to see how to run the stage.dont rush comands for start and finish finger out of trigger,when running side to side keep gun pointed down range,all the paper gets 2 or three,steels 1,remember priority behind cover called slicing the pie,and tactical sequence no cover, near to far and every target gets 1 round before any targets get a second pay attention to stage descripion it will keep procedurals to a minimum and be accurate speed comes,

what he said

thats the one........... except i mounted mine to the primer feed mechanism.trying to keep it out of the way.

i got a five dollar pedometer,took it apart soldered wires to the pndulium and stuck it on my 1050 with a switch, instant digital round counter.got the idea here and it works.i cliped it to my primer feeder tube, switch just below it i am excited at least for now.till sumtin else excites me.............lol

2- 1050,s small and large.............

pull your bullet out after crimping.should be a faint line around the bullet no gouges,a lite ring and they load better into yuor gun.

i use magic 1050 dust want to buy some..........lol

could be ,cant see it from where i'm sittin.........

sounds like primers not comming off decap pin and getting flattened in the swedger,modify the pin so the spring snaps up and down when removing primer from shell all will be better,maybe.

3.2 tg for long barrell 3.4 for short barrell glock 34 0r 17 nice round cant say enough about it.watch the slide movelol

stick with the tite groop try 3.4-1.144 nice shooter flat and accurate.

can we close this now?

i got 2 1050 loaders and love them 9 and 45.

i agree

i have read this for 2 pages.close it, because some one has a problem and cant wait 2 extra days,come on,before i ordered from brian i checked him out at dillon.they said,he puts in orders evey day at the end of day arizona time,as did brian tell me him self.they said he was 1 of there best dealers.i made my order,some how i got the amount wrong when i sent payment,brian notified me about my mistake,but he still put my order in and i corrected the problem he could have waited but he did not,so for your first post here i think your problem is un founded and not a good way to start your career on this site.just my opinion on your waste of my time reading your bull.