Q/ Belling on a second toolhead?

[Ner]

Sup guys

 

Question. Dillon 750. 9mm

I want to move sizing/depriming (1 die) and only belling (2 die) to a spare toolhead

 

What do i need to make this belling works.. Is it only Powder die + powder funnel or do i need a whole powder machine for this? 

 

Or mb there are some other tricks how to make belling without shenanigans

Edited December 13, 2021 by Ner

[Sarge]

The hopper Assy needs to be installed or else the funnel will just push out the top of the powder die

[ddc]

If I understand the question then get a dedicated flaring die such as the Lyman M die or something similar.

 

[Ner]

8 minutes ago, ddc said:

If I understand the question then get a dedicated flaring die such as the Lyman M die or something similar.

 

Yes! that could be it..thank you!

[George16]

You can buy it from MidwayUSA, brownells etc.

 

Lyman 9mm M die

 

https://www.midwayusa.com/product/1011246697?pid=600695

 

Or you can also place a WTB ad in the classifieds for a 1050/1100 9mm hold down die. Majority of 1050/1100 owners (including me) get rid of them from their presses and use different hold down die from another manufacturer (I had been using FW Arms hold down die since it holds the bottom of case instead of the case mouth).

[Ner]

1 hour ago, George16 said:

You can buy it from MidwayUSA, brownells etc.

 

Lyman 9mm M die

 

https://www.midwayusa.com/product/1011246697?pid=600695

 

Or you can also place a WTB ad in the classifieds for a 1050/1100 9mm hold down die. Majority of 1050/1100 owners (including me) get rid of them from their presses and use different hold down die from another manufacturer (I had been using FW Arms hold down die since it holds the bottom of case instead of the case mouth).

Thank you!

 

2 hours ago, Sarge said:

The hopper Assy needs to be installed or else the funnel will just push out the top of the powder die

And you too

[AHI]

On 12/13/2021 at 10:25 AM, Ner said:

Sup guys

 

Question. Dillon 750. 9mm

I want to move sizing/depriming (1 die) and only belling (2 die) to a spare toolhead

 

What do i need to make this belling works.. Is it only Powder die + powder funnel or do i need a whole powder machine for this? 

 

Or mb there are some other tricks how to make belling without shenanigans

if you wont to stick with Dillon . the powder die for the AT550

https://www.dillonprecision.com/at-500-powder-die_8_4_23631.html