icestud

Thank you all for your replies and Thank you dtuns for the Video

Thank you All for your replies Why not Slide Glide? to heavy?

So a follow up question, what spring weight should I start with?

Thank you Joe4d

I have read 5-6 of the threads here about the SA Prodigy's and the first thing I see is the advice to change out the Factory two piece guide rods, I have not seen a reason. Is it because of the two piece design? Or the extra steps when removing and reassembling? What are the Cons of the factory guide rod? I recently picked up the 4.25" model and have been doing a lot of reading about what people have done to help with the issues. I have only field striped it and did a thorough cleaning of the mating surfaces of the slide to the frame and reassembled it with some Enos standard viscosity Slide Glide. I hope to hit the range this weekend. Thanks Matt

Thank you for taking the time to post the spring info! Much appreciated!

Thanks for the spring info! looks like a great mod.

Thanks Bob, yes it is. I take it the 1" pipe fits fairly snug in the square hole? One more question, what is the system you are using to drop the cases through? ( the Spring case feed tube ) Currently I am using the plastic tube from Dillon, I like the idea I can mount my case feeder off center

Can you post a picture of the back where your case feeder attaches to the pipe? Please Thanks Matt

Thanks for the tip on the 9mm major, BC Itdmstr, that is my plan tonight Thanks Again Matt

Thank you for all the replies. I will add that after I roll size they are not going all the way in the case gauge, some will stick out maybe 3/16 some as little as 1/16 I'm questioning whether or not the dies were ground correctly I should add this is a mix of ammo I have shot out of several 9s and range pick up brass Matt

For those of you who Roll Size with a CasePro 100, shouldn't the rolled case fall into a case gauge after rolling? Thanks Matt

Lemi Shine “Original Removes tough spots and film” is what’s on my label

Have you contacted Rick? AKA Mr Bullet Feeder? he's always been very helpful with quick responces.

When you search, use Quotation marks around what you're searching for IE "back up camera" that should get you what you're looking for

Here's one

Replacements can be found at the Dillon web site Small Tube Part # 20533 Large Tube Part # 20534 Or try McMaster-Carr I got a piece of Lucite Plastic Tube from ebay that was 3/4 OD 1/2 ID by 24" long and it works great for 9mm, you will have to cut it down from 24" to fit your setup Matt

Sorry I should have copied your question, you asked “Where can I pick up this Kroil”

Not being a smart ass, but try Google

Get your self some penetrating oil like Kroil and let it soak in for a few days

Casepro 100 with Dillon casefeeder, I roll size all my 9mm brass works Great

I went and bought Dillon Blue material and had the wife sew one up

What are the advantages of a stand alone mount? I have mine mounted on my S1050 and have not had any issues with 124 gr X-Tream bullets

Do you know why the primers were accumulated in the bottom of the magazine shield? Did I miss what Dillon machine this is?

As long as you are ordering from Reloading Innovations may as well add the Spill Stop to help with powder spillage. Check out In-Line Fabrication for the case feed stop.